SP13 2pin/3pin/4pin/5pin/6pin/7pin/ 9pin Waterproof Aviation Cable Connectors,Female Plug and Male Socket,LED Light Power Connector (2pin, Panel Mount-Plug(Female)&Socket(Male))

I’m mixed. Sure, it’s somewhat flimsy, has no instructions and has several frustrating gotchas. And it’s not cheap enough to balance that out. But on the other hand, it’s actually pretty nicely designed and built. You just gotta take time and care with it. Almost worth the price.During install, I almost immediately stripped the threading (between the connector and barrel) when I hand tightened it. As expected, it just got worse with repeated attempts. I wanted to use this for 110V, so was worried it would be unsafe, as pulling on the connector might have exposed the live wires.Until I realized I needed to tighten the nut above the thread, revealing slightly more thread for a lot of extra grip. Maybe a veteran wouldn’t have made this mistake, but some simple instructions would have gone a long way. That, and the fact I was able to damage the threading with gentle pressure out of the box, is just ... disappointing.Especially so, because the design is otherwise pretty nice and build quality is ... actually pretty good. It’s not going in any fighter jets or medical scanners, but it’s definitely not junk, and is more than robust enough for what most people will throw at it. A little flimsy in places (end cap screws), but not where it really matters for safety or performance.Very easy to solder, lots of other nice little features during install. No crimping tool! And it looks like it would keep most weather-borne dust and water out. (I wouldn’t dunk it, but like ... that might actually work.)Connection holds plenty firmly without using the screw, which is great for easy disconnection with one hand. And it’s light and compact. These factors were important for my use.Probably won’t buy again: mostly because of the price. But I would be _tempted_ to. Eight bucks is just a little bit 😏

The connector is NOT waterproof as claimed. There is a hole in the middle of the connectors as shown with a yellow wire in my picture.

good product. need something more rigid but this will work on small projects and applications.

I just installed this in a bulkhead in an outdoor weatherproof housing (4 pin). The threads for the bulkhead connector are too loose and when you try to tighten it in the bulkhead it slips. The rest of the connector seems well made. I normally buy USA made connectors like this but decided to save a few $$$. I guess you get what you pay for in this instance.

Partly my fault, I should have looked closer at the size of the pins, they are quite small and not as robust as i needed. They did work, but not great and didn't handle the amount of current i was needing. Would work alright for low voltage control signals or communication type signals.