SEAFLO Accumulator Tank Water Pump Flow Control Internal Bladder 125 psi 23.5 oz

Fits easily and works great, good quality

Used this in my motorhome. It was so easy to fit too. It was a bit fiddly trying to get it to be pressurised 3psi below the high output pump I use. It has quietened the pipes down a lot and eliminated the pipe hammer I used to have where they rattled on the motorhome body. Silence now. Perfectly happy with my purchase.

Works really well, smooth flow out of the system

Good product, working very well on a 12v water system

Good Value

I purchased this pump as part of a camper conversion. I could not test it straight away as the plumbing wasn't complete. When I finally tested it, six weeks after the purchase, I found that the pump not only was so weak it was useless, but it mould not turn off.I looked through the reviews and found that I was not the only one to complain about it not turning off.I contacted the seller but did not receive a reply.It is imortant for me to say that I did try all of the obvious tests such as ensuring no leaks where air could be drawn into the system.I May as well have washed my money down the drain, but I obviously not use this pump to wash it away with.

Fitted to my motorhome as pump was shown noting due to water saver shower head , easily fitted though watch the fittings provided are very tight in standard hoses , once fitted plugged on tyre inflator verified pump cut in pressure and charged accordingly , works a treat in fact taps run 8-10 seconds without pump restarting , since fitting the hot system which often dumped on pressure safety when hot had also settled down so up to now good buy and comes with 2 year guarantee.

Has it fixed the pump oscillations? yep totally fixed.The product feels well made but a few improvements would make it even better.Nowhere does it say what orientation the device should be mounted? I expected you can mount it an any angle but it would be good if the instructions said that..1/2” BSP thread would have been a better choice than NPT. OK you can probably get away with putting a BSP fitting onto a nylon NPT thread but you’ll mangle the threads but it will probably seal.