NewYallPack of 4 Front Rear Left Right Driver & Passenger Side Power Door Lock Actuator for Lexus GS300 1998-2005 GS400 1998-2000 GS430 2001-2005 RX300 1999-2003 for Toyota Prius 2001-2003

These worked great!!! Installed the front, passenger door actuator in a freinds 2003 Lexus RX300. Found install video online and after a bit of fiddling, got the actuator working again. But, as others have discovered, the key fob(s) no longer worked. Found a solution after a quick Web search. The replacement actuator needs recalibration. Unlock and lock the drivers door with the key, then unlock and lock the passenger door (the one with the new actuator) a few times to recalibrate. Try out the key/fob buttons and celebrate your successful door lock repair!!!

Bought a set of 4 but only installed the rf and rr locks that weren't working. Fit perfectly and work great.

After reading online, I wasn't sure how this would work as some people suggested that it may not work, or I need to just remove the motor and swap that out with the original. Anyway, after installing 3 of the 4 doors, first thing I notice is that both of the remote do not work now.I spent most of time trying to reprogram it, over and over, and it still wouldn't work. Now, from what I read, that's a common issue where you just need to activate the alarm for it to reset itself and the remote should work. Well, for whatever reason, that didn't work for me either.Finally, I realize the front passenger side, whenever I use the key, it wouldn't lock or unlock? So as it turned out, one of the 2 rods that's connected was off, so I had to remove the door panel and also the door handle this time to reattach the rod. After that, everything was working like original.

Two of the doors work just fine. One of the back doors won't work at all. And the front door I'm still having problems with for some reason I have to slam the door I've tried making adjustments I don't know what it is

Replaced all four door actuators with these, while trying to program my new keyless entry remote. Car goes into a “security mode” after the installation. You need to unarm the alarm by doing the following steps (from club Lexus):1) Lock your doors with the key on the driver's side door, then wait until the red security light goes from constant on to blinking (about one minute) this sets the alarm...2) Go to the passengers door and unlock it with the key and open the door, this will set off the alarm then close the door and go around to the driver's door...3) Unlock it with the key then open it, while it's open use your remote's unlock button and that should stop the alarm and activate your remote...After I reprogrammed my remote, the car accepted the program, but the key wouldn’t unlock all the doors and the alarm would go off. This step did the trip to unarm the alarm and my remote was programmed successfully. Read many forum threads where they used the motor from an “aftermarket” actuator in the stock ones, but these worked just fine for me.

keyfob stopped working. dealer says aftermarket arm on actuator is slightly out of spec - just enough that car throws an error.

24 hours into the install and passenger side that was replaced working great 👍 installed 12.31.24 we will see how they hold up in the southern heat. I also added some grease for the hinges whee there was from factory got everything linned up and super happy my keyless entry is functioning properly!

Fit perfect like OEM on a 2000 Lexus rx300 have all door locks working now! Great deal