General MotorsGM Genuine Parts D7096C Fog Lamp and Cargo Lamp Switch

Absolutely great product OEM Quality or better. Easy for most DIY'ers to install. If you need some reassurance YouTube has some good videos. It sure is nice having my Driving/Inclement Weather, Lights working again.☆☆☆☆☆ Five Stars all the way !

If you have a 99-06(07 classic) GM full size truck or SUV and need to replace a bad switch or add foglights to your vehicle, this is the Factory OEM Fog/Cargo light switch you need. Works perfectly and Fit and finish are as expected. i didn't even notice that my old switch wasn't lighting up until I replaced it with this to add foglights.

I purchased this for a 2005 Chevy 2500HD. The old switch failed because the fog lamp button wouldn't reset properly. I assume something happened inside with the spring mechanism. This switch fit perfectly and took me about 7 minutes to replace. Simply lower your steering wheel as far as it goes, turn the key without starting just enough to allow you to put the transmission in 1st gear (lowest handle position. Make sure you put the parking brake on) then take a small screw driver and pry off the plastic frame around the dash. Take note of where the clips are to make it easier when you replace it. Don't force it. Just work it easily and it will pop off. Now you have access to the switch. Use your small screw driver to pry the clips up on the top and bottom of the installed switch. You'll have to wiggle it a bit to get it out. There is a wire harness on the back of the switch. Pull it off by lifting the clip on the connector. Then just install your new switch and perform the steps in reverse. Very easy...I don't know the long term reliability of this switch, but it certainly went in easy and operates fine.

This switch controls more than I thought. By replacing it, not only do the fog lights work, but so does the cargo light and the third brake light. The yellow marker lights on the cab also come on with the fog lights. Very cool to see it working properly. Easy DIY to replace. It just clips in place under the main instrument panel trim.

Great part AC Delco OEM! You get what you pay for.

Good

Cheaper than the dealer and restored factory operation. The silicone return plunger inside these fails after years of use and abuse requiring replacement for the switch to be able to spring back after depressing it. I'm not sure if they fade to white overtime or if some combination of use and sun fade causes them to light up white overtime, or if they changed the color but these are a more light blue when back lit vs my older yellow/white factory back lit components.

Works as it should. Simple fix. Poor design on GMs part. The little rubber button (nipple) under the fog light switch was split on my old switch which allows the button to go in but not pop back out. They should have used a spring instead. But this fixed me right up! Just be sure not to jab at the fog light button and it should last for years. Would buy again!