QILIPSU Junction Box with Mounting Plate 110x80x70mm, ABS Plastic DIY Electrical Project Case IP67 Waterproof Dustproof Enclosure Grey (4.3"x3.1"x2.8")

The media could not be loaded.  Nice exterior project box that I used for a WiFi extender that needed protection.The clear cover uses proprietary screw lugs that you have to tap into place on the cover - see the short video. Once installed in the cover, they lock down tight. They supply on extra screw lug.Worked well for me, has many uses, would buy again.

I used it to conceal a voltage power supply, DC. Looks good.

I used two of these for enclosures for Arduino boards for a project. They were easy to set up, drill the holes I needed through, and mount where I needed them. I ended up using some spacers that came with a TV mounting bracket and longer screws to bring the mounting board higher up, then cutting a corner out of the board to run the wire below. My boards have OLED displays and I wanted to see the screen but hide the mess.

Great project box . Heavy duty with great seal on lid

The box I got had a few slight surface blemishes in the clear cover. Perhaps I can polish them out. But the time and date stamp molded into the cover was disappointing. I would have preferred that to be done on the back side of the bottom. The plastic was easy to drill and so far seems to be holding up just fine. Over all the box is fairly rigid for it's size. And since my project will be used strictly indoors, I'll remove the cover gasket to make it easier to latch closed. It did come with a hardware package to fasten the internal building plate. The plate was one of the nice features I like. I can assemble 99% of my project on that, then just install it in the box and I'm nearly done. I just wish the hole pattern in the building plate was either on 0.1 inch spacing or better yet nonexistent. If I buy another one with that building plate, I'll just replace it with a solid piece of G10 instead.

Overall great unit. Used two of them to house a bunch of telecommunications and LED lighting control equipment. Waterproof, quality solid metal latches and the included "screw-down" perf board is fantastic. So easy to quickly mount equipment and somehow everything just managed to always line up with the holes. Easy to drill through the sides and easy to mount. My only complaint would be that the size of the threaded inserts isn't listed anywhere. Took a little bit of guesswork to find the right hardware (I needed longer machine screws than provided as I was standing off the plate a bit.) Well worth the money for a very strong, well built unit.

This worked quite well for my application and holds all of the logic circuitry for my heat conversion. I suggest a 6” bit to anchor to the wall as the screws go through the case in a thin tubular channel that can’t be reached otherwise.

Great item and amazing customer service! I'm using it for my CCTV and LED strip setup, it works great and even when I had a tiny problem, customer service was there to help me out. You can count on QILIPSU for your professional configurations, it's not just a store on Amazon, it's a top quality brand with REAL warranty.