Hydraulic Cylinder Welded Double Acting Cross Tube (1.5x4)

Worked well to replace the boom cylinder on a Terramite T5c.Had to get some SAE8 X 1/4” adapters to fit the existing hoses.The bottom mount was a bit tight, just ran a flap disc on each side a bit. Then it dropped right into place. Appears that it would also work for the stick and bucket cylinders even though the bore is a bit bigger than the original bucket cylinder. Need the next size up for the front bucket. (See the chart on the listing)

I purchased the cylinder to use on the tilt of my Tractors front end loader. The install was simple and straight forward. Simply install a pin at each end' add the hydraulic lines and off we go. The cylinder worked well for the first load or so. Then the problem came when the cylinder shaft bent. Mind you the old cylinder on the other side never bent. So I called to get a return number. Just to learn that a bent shaft was not covered under warranty. I emailed the customer service lady's supervisor only to get an email that said no warranty. The cylinder was nistalled wrong. So buyer beware if you buy the cheap China stuff be ready to replace it as when it breaks it will not be under warranty.

After about thirty hours of using my tractor with these on it they are holding up well. I sometimes abuse my loader and do things I should not but they are doing just as good as the original cylinders. I had to grind the shoulders 1/4 inch narrower to fit my tractor and use fender washer on the other end to keep them centered.

Excellent product for the price, it uses an O-ring fitting on the cylinder. It is universal though, it may require custom fitment. Same price as a rebuild kit for my skidsteer, can't beat brand new versus rebuilt.

Used these on a John Deere 2210 compact tractor to replace the front cylinders that were leaking. Takes a little retrofit but they work fine. and a third of the cost of JD cylinders.

Purchased as a replacement for my Ford loader. The dealer wanted ten times the price. It took welding an end on to replace the original, but it fit good and has held it's own without leaking or any problem for over a year now.

Arrived on time and undamaged. Works as well as expected. Now I need another to replace the other side. For the price I won't even attempt to repair the other cylinder's on my little loader. The re- seal kits are inexpensive and available. If you have a small Jon Deere or Myanmar I highly recommend these.

Super wide mounting base. What does this fit? I can definitely say its not for my tractor. I may have to rewrite a review if i can weld a different bracket to use it...