TYC 11-5078-00 Toyota Corolla Driver Side Replacement Tail Light Assembly

The product looks as good as the orginal parts from the manufacturer. It little bit on shiny side, but I assume it will be diminish with time. The lights glow well in dark.Fits exactly the way it should. Very easy to install, took my about 10-15 minutes.

I bought this to replace my passenger tail light, and directly out of the box this assembly was as easy as pulling back the carpeting in the trunk, locating the screws, and directly swapping the old tail light assembly with this one. The molding is spot on and flush with the body of the vehicle, and even had bulbs provided inside for instant use. 5 STARS!

Great product arrived quickly and worked great!

Why I bought this...We have a 2001 Corolla LE. The actual tail light assembly was not bad but some of the plastic bits had broken off of one of the bulb sockets. This was a problem because it caused the bulb for the passenger side brake light to keep popping out. The part that was broken was a clip that catches a ridge on the male end of the bulb and holds it in. I could not find that exact wire harness here on amazon. I didn't want to buy it anywhere else because I don't want a bunch of accounts on every website known to mankind. The only way to get the parts I needed was to buy the whole assembly.So, there's not a lot to say. It comes with the bulbs and all the parts I needed. The old one was easy to get off (technically you're probably better off if you have a deep well socket in the right size but frankly, I just used pliers because I didn't have a deep well socket in the right size. Anyway, it went on easy enough. The bulbs were all good. Everything works.If I had anything negative to say, I would definitely agree with the guy who said the fit and finish isn't exactly perfect. It looks a little wonky along the top edge (you can even see it in the Amazon photos). If you're really looking at it, it's obvious that it's not quite as precisely made as the factory part and is of somewhat lower quality. But then again, it's a 20 year old car and the original factory part lasted this long. I'm sure this replacement will last longer than we keep this car at this point. A brake light that doesn't work reliably is a safety hazard that nobody needs so $50 is not a bad price to pay for that.I might have attempted to get the OEM part if I'd had the inclination and the price wasn't significantly more. I don't know how much the OEM part would cost and probably don't want to know. If it works and it lasts 5 years on a 20 year old car, good enough I suppose.

This was exactly what I needed. I replaced one before [from someone else] and had to make it "fit" this fit like it belonged... the extra bonus is it came with all the bulbs!! Great product!!

Might rear left tail light had a small crack on it that caused it to fail state inspection. I checked a few repair shops and the wanted at minimum $50 to replace the light plus the cost of the item. I found this piece on Amazon and was able to get it with free two day shipping. It arrived perfectly intact and new and was very simple to replace, requiring only a wrench and about 10 minutes of time.I would highly recommend this product to anyone who needs to replace a tail light. I have had to purchase similar lights in the past and this part is of the same quality, and I have had no issues so far as far as durability or operation. When compared with the original 14+ year old part the build is still just as solid and apart from some writing and lack of dirt, the part is indistinguishable from the original

Replaced my 1998 Corolla LE's rear light fixture. Easy to install, looks fine, everything worked first try.

Somebody backed up into my car and cracked the RH tail light. I ordered this piece as a replacement and i am satisfied to a good extent. However, there are some downsides:1. The trim is of low quality, especially the top edge. You can clearly see the red lens not fully covering the top edge of the assembly (see picture).2. The bolts are kinda short and are only zinc plated! Usually, quality auto bolts are plated with zinc then finished with yellow dichromate which gives better corrosion resistance than clear chromate.3. The color is slightly brighter than the original OEM piece (not a big deal, though).4. The light bulbs are cheap and the filament is so thin. If you still have the OEM bulbs, better use them.Overall, the piece fits okay and does its purpose. Though i'd have been more satisfied if the trim was of a better quality.