HOTRC DS-600 6CH 2.4GHz RCトランスミッターとレシーバーリモートコントローラー DS 600 PWM 6チャンネルレシーバー付き RCボート用 (PWM RX付き)

Bought to use on a RC lawn mower that I didn't want to use my expensive drone controller for. This one is actually very well made and feels quite durable. The setup is very poorly documented and it's likely they didn't even use google translate to generate the translation for it. However it is fairly easy to figure out and basically has 2 operating modes. One is standard Channel one is forward and back and channel 2 is left and right on the joystick. mode 2 is differential steering for channel 1 and 2 (or 3&4 if you set that up) This is where you would set up a tracked or "Skid steer" control. if things seem to be spinning the wrong direction make sure to just change the direction your motors spin instead of trying to re-program the controller as you would normally. Range is great and the included receiver has device battery telemetry meaning it can tell you what the voltage is on your RC vehicle.

Works awesome! Battery voltage telemetry is glitchy where it doesn’t get signal back all the time but other than that it’s good.

Worked great out of the box. The instructions were not great. I'm using it for a kayak trolling motor control and steering. Forward and reverse seem a little sensitive but I just lock it in a low speed and I'm able to toggle it up or down to increase the speed. The extra channels allow for a lot of additional outputs which is nice. For the price you can't go wrong.

Not seen any other one-handed, wireless UI item like this out there and it works great, and is so low cost! Buying some backups and for future DIY projects. 1) Above the (2) throttle and stirring channels of the thumb stick, it actually has (4) more RC channels as ON/OFF buttons on it that can be used for whatever On/Off use-cases you want. 2) It has a very cool "carpal tunnel preventer" ... a throttle trigger button on the front that locks the throttle level for cruising at a set speed vs. pushing stick FWD all the time. Even has wrist strap so you don't drop it, or free your hands up while it hangs. 3) Hooked the RC receiver it includes to Arduinos and ESP32's and it receives standard PWM pulses and it is very easily a cool wireless UI device for DIY projects or even controlling standard (2 CH) RC vehicles.

Fonctionne très bien pour contrôler mon moteur minn kota de kayak