Broan-NuTone 413001 Non-Ducted Ductless Range Hood with Lights Exhaust Fan for Under Cabinet, 30-Inch, White

Works great, easy install, looks clean and well made!

The Broan-NuTone 413001 is a solid choice for anyone looking for an affordable, non-ducted range hood. It’s easy to install, fits perfectly under a 30-inch cabinet, and does a good job at clearing smoke and odors. The built-in lights are a nice bonus. For the price, it's a great value if you're looking for something simple and effective.

SECOND TIME BUYING THIS FAN , THIS ONE DIDNT HAVE THE COVER FOR THE LIGHT BULB , HAVENT USED , BUT THE OTHER MY TENANTS OVER USED AND ABUSED THE FAN

It was exactly what I wanted. It looks good and works as it should. I already had one in place, so replacement setup was easy. The only issue I have is that it doesn't come with a light lens. You have to buy that separate.

Awesome item. Easy to install. Uses a normal light bulb, so super easy to replace. Very clean looking. I edited this review after hearing back from customer service about the original issue (see below) their suggestions worked and removed the residue from the protective plastic sticker that was on the hood. This item arrived with a protective blue plastic peel off piece across the front of the hood. After installation, I removed this blue plastic to find that there are marks all over the front of the hood now from that blue plastic. I tried first cleaning them off with just a soft rag and water nothing. Then I tried Windex that didn’t work. So I tried a soft drag with some Dr. Bronner‘s soap and that had no effect either. Otherwise it is a lovely hood. Not sure how to get rid of these ugly marks. I took a photo, but it’s very hard to photograph.

This ductless range hood was easy to install and works good.

I’m pleased with the price and design of this item. I searched around for awhile to compare prices. This was the best price I found, with the features I was searching for.

I replaced a 43 year old mobile-home range hood because I was never able to use it due to the exhaust fan vent closure flap never working and the hole faced north; the direction we get all of our extreme cold and winter wind from so I had sealed the fan opening off. In the winter time if I did not keep the cupboards above open my cooking oils would freeze. The grease continued to build up even with continual cleaning until I could not stand it any more. I did not know they made a non-outside-vented hood range until I went looking for a new vent hood. Because the lip of the cupboard is a bit lower than the actual base of the cupboard I had to use some 3/4" plywood (2 pieces of 2" x 11") as "spacers" on both ends to make the hood level. I attached them to the bottom of the cupboard and then used shorter screws to attach the hood to the plywood. I used styrofoam insulation and heating-duct tape to seal off the original vent opening. The fan is very quiet and i could feel the difference in the low and high speeds although neither of them were real powerful. I have yet to need to use the fan since with the hot weather we are still having I have not used the stove top to cook any fatty foods. I like the white verse the brushed aluminum of the original hood; it makes it look lighter and brighter and should be easier to wipe off each time I clean. I did install this by myself and the only time it would have been convenient to have help is when I went to lift it up and attach it to the cupboard - I am just over 5' and of retirement age, but I made a couple of props to hold up the back and other side while attaching the first side. There are only two colored wires (white and black) which you need only to attach to the original white and black wires, and then attach the ground wire to the green screw. There is a plate covering the wires held on by a small black screw. There are 4 short screws provided (but I used longer and wider threaded screws) for attaching the hood.

Easy to install

Muy practica para cocinas pequeñas

Fit it the spot where we were putting it

Replaced an old Mastercraft range hood. Fit perfectly in the existing spot without having to drill any new screw holes. Looks modern and sleek. Fan is quieter than the old hood so I can't complain. Installation was fast and easy. Would recommend

This is a replacement for one of the exact same brand that we had for 25 years, it was still working but didn't look good anymore.