20 Pack 4 Pin 10mm Solderless LED Strip Connectors, Clear Track Lighting Connectors, LED Pin Connector, with 16.4ft Wire Lights Strip LED Strip and

The easiest and best way connect LED Strips to cable. They can be a little big, so hiding them in an install is kinda hard. But the ease that they add to getting the job done makes it worth having to use a little more brain power in designing to hide these being clear helps. You'll get it.

These worked perfectly for my WYZE Light Strip Pro! I've never worked with LED strips or connectors before, so if I can do it, you can too! IMPORTANT!! Make sure you either unplug the light strip from the wall outlet entirely, or at least the one strip that you are working on! First, cut the WYZE strip at one of the cut marks and carefully peel back the waterproof covering from the strip (see video) until you have enough to put into the connector. Slip the strip into the connector end (that doesn't have the three hole openings in it), and slip it in on the flat side away from the metal contacts. That way, when you close the connector end, the metal pieces will pierce the strip and make contact with the copper inside the strip. Then, take the red/green/white wire that comes with this and pull apart the three wires about half an inch or so, then put them into the other side of the connector (that has the three holes in it; see picture), then close that connector end. Do this same process with the other end. Note that you MUST make sure you match the colored wires to the strips on each end. So if the red wire is connected to the strip where it says "GND" on one end, then you need to make sure the red wire on the other end is connected to the "GND" of the other strip. I then reconnected the WYZE strip, and it worked the first time! The lights still cycle in the different modes (wave, flicker, etc.) as if the strip was connected normally. Really happy these worked out! It really wasn't difficult once I did it the first time. Hope this helps someone else!

These were used to put lights in some bookcases. I really wish I could unplug and replug these in. That's my only minor complaint. Otherwise, happy with this product.

These worked great on 2815 LED strips. They make a solid connection on both the strip and to the wire. Need to make sure you line up the LED Strip connector. It bites in really solid, cuting into the connection. Not recommended if you want to only make a temporary connection as it bites into the pads on the LED Strip.

I bought these for a lot of connections, and they are very hit or miss as far as holding the connections for the led strips. Probably should have spent more for the amount that I had to toss.