EZ-POUR HI-FLO Spout with Reducer Tip & Vent Kit (2 Pack) | Fits 1-3/4" Openings | Compatible With All EZ-POUR Adapters | Reducer Fits Older Tanks, Water Jugs, and Industrial Containers | Replacement Spout Kit (60060AZ)

This is my second order of these spouts. They are awesome! I fill my tractor with a 5 gal can and the original spout took forever with a full can. And the fill cap is about 4 feet up on my tractor. The HI-FLO gets the job done in about 30 seconds.

This kit is good for 2 containers, so you can replace the awful "safety" ones that leak and flow super slowly. There are two thread styles, so they will fit on most containers snugly. One is black and the other is the yellow one. The kit comes with vent plugs that install really easily. DO NOT overdo/ream the 1/2" hole drilling, or it will be very loose and leak. You will want to add the smaller nozzle for filling things like chainsaws, weed whackers, and push mowers. The gas flows out really fast! Super easy to install and use.

These are great add-on for those useless so called “green vapo-lock” fillers that take four hands to work, then leak; on those overpriced $40+ fuel cans. Back to simple and safe. Be careful where you drill the vent.

These work great and are simple to use.

Does fit on the Midwest Harbor Freight Jerry Cans. I did NOT drill my cans for the vents because I don’t want metal in my gas tank. Certainly an upgrade from the stock nozzles but flow rate is very slow without any vent. For me, it serves as punishment if I’m fool enough to run out of gas! The extender nozzles are very handy.

These are awesome, I have them on all my gas cans. The flow rate is four times what the "safety" spouts do which is a huge benefit when you're pouring 5 gallons into a UTV, tractor or zero turn mower. They seal well enough to travel to and from the gas station with no leaks. My oldest pair is over 5 years old with no signs of breaking down.

works great, highly recommend,

I picked up several gas cans to fill in case of emergency (storms, etc.). They all had those red spring loaded vents on the pour spout. I can not get the vent to pour gasoline, as it needs to be held while holding a full can of gas. The EZ pour fit the can, and the vent installed in seconds. The instructions recommend not using a twist bit in order to cut a cleaner hole, so I used a 1/2 inch spade bit and went slowly with it. I followed a recommendation I saw to not drill the vent hole on the tank seam, as it can lead to splitting. The vent plug snapped in, and the can now works like it should.

Great, avoids spills

I had to use the original black cap that came with the can in order to use the EZ-Pour spout, neither of the yellow caps worked with my Canadian tire bought gas cans. overall I have zero regrets, highly recommended.