SPARIN Screen Protector for iPad Air 11-Inch M4/M3/M2 (2026/2025/2024)

Ok firstly the screen protectors are very well packaged, they are in a hard card envelope and each protector is in its own foam sleeve. To Start, first create a clean work surface, something like a table or large chopping board will do. Clean the surface thoroughly to ensure there is no lint, dust etc. that could contaminate the work space. Clean the face of the tablet with the wet wipe so there are no marks then wipe with the micro fibre cloth. I also used the micro fibre cloth from my glasses case, it seemed better at getting the desired finish. At this stage also check to see if there is any lint or dust floating around. I inspected the surface by looking at the reflection, I was surprised by the amount of stuff floating around and had to clean my tablet again using another glasses wipe. The screen protectors themselves have a sticky side which is face down so any small amount of contamination will stick to the surface and leave bubbles etc. in the finish. The assembly frame is good and fitted my tablet fine (I would have found the application of the protectors extremely difficult without the assembly frame) then take the protector and fold back around 1/3 to 1/2 of the protective film using the tab and match the edge with the assembly frame then draw back the film and make sure of the alignment and that the protector fits into the assembly frame. What a lot of people will do is press down on the protector when they are removing the film, refrain from doing this as it could create stuck areas that could trap bubbles. (I did this on the first try). Then I started at the left hand side and drew my finger towards me just inside the assembly frame. This sealed one side then working backwards and forwards (towards me and away from me) slowly moving from left to right with every pass until I reached the other edge. This gave me an almost perfect finish. The key is to not rush and keep checking to make sure the tablet surface is free from contamination, once it gets in there forget it it won’t come out. I found this out with the first protector (glad there were 2 in a pack) where I managed to get some dust in under the film and created bubble central. I tried to clean it out but because of the stickiness of the film it just made things worse.

These are great screen protectors. I use my Apple Pencil with all of these all the time, and it works perfectly without affecting touch sensitivity at all. The screen protector doesn't get scratched, but I keep mine in my case all the time so that helps. It has a cutout so it doesn't go over the front camera and make it blurry. The installation can be a bit fiddly, but the pack comes with two, so if you stuff up the first one, you can try again. This is the second time I've bought these, since I dropped my iPad and my screen protector cracked (but my screen was perfectly fine! clearly, it has done its job). I would recommend these. I have the 2024 iPad Air, for reference.

Very good

Not the easiest to get bubbles out, but I did it, so far so good other then that.

Works as intended and managed to apply with zero bubbles and little particles trapped under. Have used it for a couple months now (not heavy usage but still with my pencil every day to some capacity) and can only see a few minor scratches when the screen is off and the light catches it. Fingerprints don't seem too bad, and it's easily cleaned with a screen cloth. I will say I have noticed the odd issue with responsiveness. I spoke to Apple and the guy there said he personally wouldn't recommend screen protectors for ipads as they historically don't work wonderfully. But it's honestly not that bad, at least bad enough to risk going without one! And that's not to say the problem isn't the iPad itself either, time will tell (thank gods for AppleCare!!)! Can't speak for the durability with drops I guess, as I haven't dropped it yet (I treat my iPad like my precious). But I have no doubt it will protect the screen as intended if I were to!

Great quality and Value for Money - Easy to apply and no bubbles - Didn't impact the screen clarity at all in fact it may even have improved it by reducing glare

Does what is says on the tin, fairly easy to apply but not resistant to cracks - I have 2 cracks after a year of purchasing Also had a few issues with touch - a bit too sensitive on the occasion

Easy installation, no problems.

Facile à poser ! Un poussoir à bulles aurait été le bienvenu !

Ottima pellicola, davvero utile la guida per applicarla, sarebbe molto difficile farlo senza essendo una pellicola così grande. Inoltre ho utilizzato varie penne di terze parti ed anche originale Apple e non ho avuto problemi nel prendere appunti, tutte le penne hanno funzionato perfettamente

Pratique à mettre

Fácil de poner y perfecto

Desde que compre este protector, lo coloqué en el ipad y de momento sigue intacto. Sin ningun golpe ni nada. Asi que considero que es un buen producto.