C6374 170KV Efficience Brushless Belt Sensored Motor for Electric Skateboard Longboarding (C6374, 170KV)

For $49 it's a very solid 6374 motor. Good torque and decent speed. I used it on my first DIY eSkate project and got it going 20mph! Not bad considering I was using a cheap 430watt, 12A, $50 eSkate ESC with remote kit that I got here on Amazon. The motor seems very durable too (see videos). Before I used it for my eSkate project, I actually submerged this motor into the salt water (Gulf of Mexico) and tried it as "boat motor". I barely rinsed it afterward and 6 months later it still fired up, after I changed the bearings. All things considered this motor works great and for a very reasonable price. No complaints. I'm going to buy another one for an eFoil project. It’s a great value.

A little under powered with the esc that I got for them i could only find 60amp 6s esc looking into getting vesc for them but the ones I find since wires for the motor is 6 pin and these have 5 pin since wires trying to get info on the wire but they won't give me the info until I review the product

I've been using this motor for a robotics project. While it's been running great, the setup process is a pain to say the least. I did not expect much for a motor at this price point, but documentation is terrible. If you're not connecting this to a VESC controller, expect to spend some time tinkering with it to get it working. However, after getting it working, I haven't had any issues with it. PROS: great price, good motor with high torque. Cons: lack of documentation may be a problem.

I purchased 6 of these to build 3 x 2WD offroad boards and they work great. They deliver smooth and huge power, run quiet and cool even on steep uphills. Vesc Tool detects them at 52 to 53 amps. That's plenty enough for me, and I have to limit the top ERPM to 60K otherwise the board are just too fast. They do come with 5 wire sensor cable. Not a problem, just wire into your 6 wire harness and skip the temperature pin. One of the motors was faulty and the sensors were not detected and it reported a slightly lower max amp. I asked for an exchange and the vendor immediately sent me a new one, no questions asked. Great service and thanks!

It was bigger then 10mm and my gear pulleys didn't fit. So now i have two motors I can't use.