39.5'' H×24.5" W Metal Chiminea Fire Pit, Wood Burning Fire Pits with Grill, Square Chimineas Fireplace with Mesh Spark Screen Doors& Fire Poker, Firepit for Outside, Garden, Yard…

I chose this fire pit because it was similar to my old one. Easy to put together, sturdy and good design. I like it with the door verses a cover. We have a fire every weekend. So far I love it!

My husband and I were looking in big lots for a firepit but the pricing were hugh so we came to Amazon and found this one on sale for less than 50 bucks. We love everything about it, the material, the look, its not too heavy, and its super affordable. The only cons is that the handle gets hot and below the grass may burn so we brought some stepping stones to place under it while it burns the wood. Other than that, highly recommend! 10/10

I love the look of it, and have bbq many meals on it but the tray that holds the logs is warped, it happened after maybe two uses, and the logs can fall through if not aligned properly to hold down the warp side.

This is amazing. It looks awesome & the heat comes out towards you. We've had several firepits & the heat just went up, as there wasn't a top, but with the top on this one the heat comes out, so you feel the heat. Putting it together was easy, but make sure you have the pegs for the grill facing each other. We put it all together, but the grill piece didn't fit into the pegs, so we had to take half of if apart & move 2 of the side arms so the pegs matched. It is a must buy.

It was easy to assemble, sections fit well. Yes, it is thin and lightweight, what do you want for less than $100.00? It seems to be just fine for a few fall evenings in my courtyard.

This was easy to put together and cheaper than a simple BBQ grill. And a big plus is that it you can also use it as a fire pit making it the best dear friends.

Easy to assemble, nice size, heavy enough to stay put but easy to move.Material is sturdy and attractive at the same time.

Instructions were easy to follow. However, on one of the side screens one of the fastening tabs was welded on backwards. Luckily I was able to re drill it on my drill press. Also the supplied bolts would not long up with the pre tapped holes in the hood. I was able to fix this by re tapping one of the holes in the hood. My suggestion would be that prior to assembly a person should use a tap and die set (metric M 6. 100) to get the paint on the supplied bolts off of them and re tap the threaded holes. Finally The directions for attaching the finial to the cover say to screw it on to the cover. Unfortunately there is no pre tapped hole in the cover…..just a hole. So a trip to my local Ace Hardware to buy a nut and some washers was necessary. But it looks nice……. Altogether installation could have been easier if the supplied bolts were longer as they are difficult to hold and insert properly since they are very difficult to hold in the tight corners you have to work in.