MATNIKS Neoprene Rubber Sheet, Heavy Duty, High Grade 60A, Black, 12x12-Inch by 1/4-inch Thick (+/- 5%) for Plumbing, Gaskets DIY Material, Supports, Leveling, Sealing, Protection, Abrasion, Flooring

I bo ught this to replace the neoprene on a fan/light. I haven't replaced it yet, though it appears to be a good quality neoprene sheet. I may find the 1/16" to be a little thick but I'm confident it will work as planned

Absolutely amazing we love these and use them almost daily!

Arrived on time and in great condition.

Smell isn't as strong as some reviews had me imagining. It isn't a bad smell, it's very similar to new tires. One issue, which mattered for my application, is that the sheet is nowhere near square. So if you need to use the full sheet, or were counting on using most of its area for cutting out smaller, squared pieces, you'll need to take that into consideration. And it's more than slightly off, it's immidiately noticeable with the naked eye. Again, if you need a full square sheet, it'll be unusable.

Used for gaskets and for a flap valve. The Neoprene is fairly flexible and has a Shore Durometer hardness of 60-65(A), about the same hardness as auto tires or O-rings. It’s not as hard as the of leather used for belts (80A), but much harder than the neoprene used for mouse pads (30A) t Don't know about durability yet, but looks like it will serve well. Don't understand the "adhesion" rating factor. This a plain sheet - no adhesive. I used Hylomar for gasket assembly.

Used this to cut out padding inserts to go in between my rear leaf springs on my 2019 Canyon to stop the common clunking in the back when driving over speed bumps or railroad tracks. Used a utility knife and two or three passes to make clean cuts. Working great so far. No more clunking in the back.

I needed a dense piece of thin rubber mat to use under a custom truck battery install. I bought a custom made steel battery box and an Odyessy battery. Once the box was installed and the battery was locked into place I noticed the battery slid side to side about a 1/4 inch. I used the rubber mat and cut it to fit the bottom of the battery tray, dropped in the battery and locked it into place. Because the mat thickness was only 1/16 it didn't inhibit the locking bracket over the battery. Now it's rock solid and doesn't move at all.

High quality heavy industrial grade rubber pad or tile. Exceeded my expectations .

The product is what I needed and performed as I expected. Used it to custom cut flat washers. It arrived on time, well packaged.

Good quality

Very happy! Got exactly what I ordered and it worked out perfectly !!!

Worked great for what I needed it for!

Très bon produit très résistant