YITAHOME Safety Bollard Post, 36" x 4.5" Steel Bollards for Warehouse, Yellow, 2 Pack

This solved my problem of people driving in a low area between my drive ways. Very substantial and good quality

I just had a A/C unit installed on my barn. Gets pretty hot and humid here in the South and the heat is getting harder to take as I get older and the humidity is not a friend to wood. Had the unit installed at one end of the attached lean to. Since this is where I store all my implements I was concerned someone would get too close to the unit and hit it.With that in mind I decided to add these bollards to protect it. While they aren't as heavy duty as you would find at a commercial warehouse or something like that, they are heavy enough for my needs (i.e. stop a zero turn but not commercial truck). They were actually more solid than I expected.Two things to note however. 1. They are sent with metric hardware. Some may find this an issue as you will need an M12 bit to drill the hole. Standard bits will not work. 2. If drilling into concrete, you will need a hammer drill capable of drilling such a large hole. Most likely a rotary hammer drill or similar. It wasn't an issue for me as I just swapped the metric out for 3/8th standard and discarded the metric hardware as most stores around here don't carry an M12 concrete bit.Please also note, your holes must be perfectly located as there isn't much play with the plate holes. I had to step up the holes on one plate because the drill bit walked on me even though it was center punched.All in all they were much better than anticipated and took no time to install.

Does the job and easy instalation.I purchased different/stringer bolts without the sleeves and used epoxy in the hole. I also epoxied the washer and nut in place so they could not be removed easily and possibly stolen

Good hardware. You just need a good 1/2" drill bit to drill into asphalt to install it and a 17" impact hex bit to fasten the bolts. When tools are right, it just takes 30 minutes to get it done and your neighbor won't hit your car parked on your driveway anymore. They must hit this pole first if they try, LoL.

This helped us pass inspection for a water heater that needed protected. Easy to install and looks great!

Make sure that the size of the anchors and the size of the recommended drip bit are appropriate mine wasn’t I had to purchase an additional drill bitAside from that everything was high quality and secured nicely to my garage floor

Sturdy and good quality

Product showed up quickly and as described, the metal was very thin similar to it being made out of steel conduit but worked for job needed and was easy to move to job.