Grille Decor Badge, 3-Color Upgrade Emblem, Grille Insert Trims

This tri-color TRD-style grille badge is a small but great-looking mod for any Toyota truck or SUV. The colors are vibrant, the plastic feels solid, and the mounting hardware is strong enough to stay secure even on highway drives. Installation takes only a couple of minutes — you just thread the bolts behind the grille and tighten them. Once mounted, it doesn’t rattle or shift. On my 4Runner grille, it sits perfectly straight and adds a subtle but sharp accent without overdoing it. For a cheap and easy exterior upgrade, this badge gives your front end a more customized look with almost zero effort. ⭐ Pros & Cons Pros: ✔️ Vibrant color finish ✔️ Solid mounting hardware ✔️ Easy 2-minute installation ✔️ Works on many Toyota models ✔️ Clean TRD-style accent Cons: ❌ May not fit grilles with thick mesh ❌ Can fade slightly after long-term sun exposure

Love the TRD logo, screws together perfect and easy, fits my grill excellent and doesn't move at all plus u can see it from far away witch i love!

Looks cool on my 2023 Tacoma

Bought in May, installed at the end of the month. Looked great. But within 2 months it faded to white, pink, and red. Yellow turned to white, orange to pink, and red is working towards pink. I thought someone was punking me when I noticed it, but there was a small defect (nothing I cared about but a distinctive small mark) in the upper right hand corner you can only see close up that is still on it. Photo of look right after install and 2 months later attached.color.

Works great for me. Don't over tighten when installing, tighten gently and not too tight.

ATTENTION!!! Before purchase just know for those who have 4th Gen Tacomas you will NOT be able to access the lower middle of the grill due to it being blocked off from inside! This was added in to a 2025 TRD Sport 4x4. The process was simple and takes a couple minutes. You will have to drill two holes properly and carefully aligned for a perfect hassle free fit! (SEE PICS) if you noticed I marked with a sharpie where the alignment of the badge threads are located and then carefully eyed the center. Once you feel the alignment is good then proceed to drill slowly and accurately two holes. If you notice from the provided pics I didn’t hit any obstructions when drilling through. I purposely placed the badge more to the left so as not to hit anything and have plenty of room for the nuts. Also, you can see I decided to add two plastic spacers behind the badge for a solid non rattling fit. I also added to plastic washers in the back too and applied the nuts. I used ONLY the socket itself to hand tighten the nuts because the socket only allows you to slide over the long screws with no problem. It’s now a secure fit and if need be can always be replaced whenever. Four stars because there’s no back plating on the badge when applying the screws behind and this caused one of the color plates to come undone. Other than it’s pretty nice!

Alright, color faded

Pretty cheap little Badge.. looks pretty good though. I'm sure the summer heat will destroy it.

Buen material

Looks good

Looks great, bolts are overly long and if you over screw them in they pop out the coloured discs in front, which are held in by an adhesive. I wonder if they will last. Otherwise they look great

Pequeño detalle que se ve muy bien

Supplied nuts would not thread onto the bolts. Had to go to hardware store to buy the right size to make it work. Will see how long it will lsst next.