RGBZONE 10Pcs 8mm 4 Pin LED Strip Connectors and 32.8ft 4 Pin RGB Extension Cable Strip to Wire Quick Connection for Waterproof or Non-Waterproof 8mm Wide SMD RGB 5050 LED Strip Lights(IP20/IP65)

Easy to install, clips tight...take your time and it works perfectly

This is exactly what I was looking for. The prongs clamp down into the extension wires and into the tape light. No need to strip back wires or plastic on the tape light. You can’t get it wrong, it’s so easy to use. No tools needed. The wires and tape are nice and tight once clamped down. They are definitely not coming off. Great connectivity.I used the 3 prong (pin) 10mm for my Feit Electric LED Under Cabinet Tape Light for a perfect fit.

still working but the sticky tape could be better

I used these to install strip lighting under and above my kitchen cabinets.The install was pretty easy. You don't even need to strip the wire, just feed it into the holes and pinch it down. The hardest part I had was fitting water proof light strip. I had to push the strip in far enough that the tiny blades cut through the rubber and touched the contact. I found opening the wedge end of the clip as far as possible and pushing the wire back as far as I could, then holding it in place while pinching with pliers worked well. I had to reset the connection to the strip a few times because it was off just slightly. You likely won't run into this issue with non-water proof light strips.After connecting, everything I tested that portion of the strip to make sure it worked and wrapped it with electrical tape before moving on.

I don't understand how the rating is that high, these lights are super cheap. Extremely dim, colors are not vivid, remote rarely works (can't have anything in the way and have to point directly at it.

Easy to install and very bright light

great products

These are nice and bright, no dead spots, and the backing holds very well.The white is more of a blue than a white.

I was very skeptical when I received it because I've had issues with products like these for coloured striplights before. Holy crap did this work like a charm. No need to strip the wires the little adapters just push right into the cable. I did have to bend in the metal tabs on the strip light side but they provide you a tool that makes adjustments super easy. Was worried about +/- issues but with each reversal everything stayed just fine and worked. Definitely recommend.

I wasn't quite sure how to use this at first. Separate the wires a little and just jam them into the little holes. I followed the pictures in the post and it worked out. Keep in mind when installing the light strip the pins in the connector should be centered on the copper points on the light strip, the connectors do stab the copper so make sure to do it right the first try for successful installation.

This can extend between two LED strips - but not between a controller and a LED strip; which is what I needed it for. Also the connections are extremely tentative on the LED strip side. You cannot handle the strip after a connector is in place or it becomes intermittent and eventually fails.When trying to correct an intermittent cable, there is no way to easily unclip from either a cable or LED strip; you might as well discard it or cut the LED strip before the connector. Really frustrating to work with, no instructions and NOT recommended.

Works great for area it was purchased for.

Thé connecter is long so if the led light is close to the stipe end it would be hard to snap connecterBut managed and satisfied