VEVOR Electric Hoist 1760lbs with 14ft Wired Remote Control, Electric Hoist 110 Volt with 40ft Single Cable Lifting Height Motor, for Garage Warehouse Factory

Installed this in my garage, ran mobile track in the ceiling to lift heavy items,too old and too weak to lift them,works like a dream,.wish I had it years ago, would definitely recommend it

What a great deal. I was looking for something more in the line of 400 - 500 lbs. I am only using to lift the top of my Jeep which is about 110 lbs. This was actually so close to the 440 lbs. version I could not resist. So glad I purchased. Works great up to about 300 lbs. Have not had an opportunity to test over that.

This was the heaviest item I ever ordered. It took two men to deliver it and I had to push it thru the door. It is of fine quailty but as I said very heavy. It should hoist anything. Given as a gift and well received.

Used it. Good for the price. I don't think I will buy Vevor again however

Simple to install, albeit a little awkward but that’s just unavoidable. Worked right out of the box and I used it to pull a deer out of a truck and hang it. Did the job no problem! Pay attention to the size/length of your lag bolts to get the most weight capacity out of the winch.

My new Vevor hoist doesn't stop and will pull in all the cable with the hook. The 3 inch disk at the cable end is much too small and will go through the stop switch lever. The 3 inch disc will tilt and pass through the stop lever. It occurs all the time unless I divert watching the load and concentrate on the ceiling at the hoist so it doesn't wind in all the cable and hook. Please send me a 4-1/2 disk. Vevor Support ignored the defect and my photo. Hello, I'm sorry for the inconvenience. Thank you for your reply. The plumb bob only has one specification. Once it hits the limit switch during lifting, the button can no longer be pressed. If you have any other questions we can help with, please let us know. Wishing you a joyful and fulfilling life! Also, thank you for your patience. Sincerely, Sharon Customer Support

This is awesome and worked great for pulling electric motors out of air handlers!

The first thing you want to do when opening this up is find the end of the lifting cable where it loops around the hook and is crimped. I stabbed my finger twice grabbing at the hook end. You'll need to put tape or something around the sharp strands of the lifting wire. Seems like something that should be taken care of at the factory. Its also slightly hidden by the red disc, so dont grab without gloves. The lift itself seems fine and is working.