GDSTIME 30mm Blower 12V 2Pin 3010 Dual Ball Brushless DC Cooling Fan 2-Pack

As described

Bought these for a 3d printer. These things are NOT quiet at full speed, but they push A LOT of air. That said, you really do not need to run them at full speed, and probably actually shouldn't. They push A LOT of air for their size, and I found that at full speed I was getting GREAT overhangs, but my layer adhesion was suffering, i believe they were cooling the filament too fast. Cut fan speed down to 50% to 75% and have been getting great results with much less noise. haven't run an overhang benchmark again yet, but I am pretty pleased with these fans. The cords are also nice and long, I can;t imagine too many people will have problems getting them hooked up unless your rig has super long cable runs

Mounted both of these in my absorption RV refrigerator to circulate air and increase cooling . The temps inside are much lower and I was able to lower the temperature settings two notches and still maintain below zero temp in the freezer. The only negative is that they are a bit louder than expected.

This is the one you want. Blow enough air to cool prints. Don't get those cheaper ones or the silent ones. Get this one and set the fan percentage to whatever fits your need.i don't think there is a lot of 12volt fans out there that can move as much air as this.noise level is ok. Not silent but not as loud as the original anet one.

These are exactly the fans I needed to repair my Xbox 360 power adapter. *However*, for anyone else looking for them for that purpose, do be advised that the polarity of the connector is inverted compared to what you need. The best way to fix this is to get a MOLEX Mini-Fit Extraction Tool and carefully swap the pins in the plastic connector. You don't NEED the tool to do it, but it makes it MUCH easier having the correct tool. For that purpose, these fans are also quite a bit noisier than the stock fan, so if that bothers you, pick something else. The cooling power can't be beat in this form factor though! They're also made with tough double-ball bearings, so they'll probably outlast the life of the console itself, lol.

I bought these to replace one on a super loud humidifier. I only needed one, but the price was better for the two than most places wanted for one. I had to de-pin the connector and use the original since it was a different style. Overall it works well, moves a fair amount of air, and is probably slightly louder than the original, but not bad.

It runs at a smooth pace, and for about a day was only about twice as loud as the original fan in my humidifier when it was new. Now I can hear it in the next room. It is an improvement for the sound of the failed original fan but not good for sharing a room to sleep.

These fans blow. And, that's just what they're supposed to do. Very satisfied.