MEALOS 300pcs 3x1mm Tiny Neodymium Rare Earth Magnets - Mini Small Round Magnets for Crafts, Miniatures and Small Models - Come with a Storage Case

These are the ideal size for magnetising model miniatures for wargaming. I use them to magnetise certain parts of the models such as arms and weapons etc to allow me to swap and change them about and they work fantastically well for this. I also use them to magnetise them to a rubber steel sheet for storage purposes to keep the models in place and avoid breakages within my storage boxes. They're the ideal size, good quality and strength and perfect for my requirements so I would purchase these again when I need some more.

I Went for the 200pcs combo and it's fantastic. I used these for Warhammer AoS Skaven miniatures. Using a mixture of sizes, I could conceal the magnets on the miniatures and heavier resin bases so I could swap between circular and square bases. A few of the magnets were easily enough to secure some pretty large miniatures such as Screaming Bell, Verminlord, Hellpit Abomination, and the small ones are great for putting on arms and weapons so you can swap around your miniatures. I recommend starting with a combo set, then if you need to rebuy the ones you find yourself using the most of.

The bigger magnets in this pack I've glued to the bases of my models for storage and the smaller ones I've used for magnetising the arms and other parts. A 3mm drill head is the perfect size to get a hole big enough for these to slip straight in and super glue is perfect for a solid connection. These magnets are a very solid strength even just 4 of these magnets hold my 80mm base Ghaz and you can easily shake the box without him falling out. There's none in this pack that will go to waste as all are a perfect size for the bases and magnetising arms. Highly recommended if like me you plan on using them for magnetising your warhammer miniatures.

They’re not as strong as equivelant-size quality alternatives, but they’re certainly not weak. Decent number for a cheap set, and a sensible range of sizes. The included long cylinder magnet is a nice addition, but it’s not much stronger than one of the individual magnets, which are an order of magnitude smaller. Wouldn’t be surprised if it was a reject batch and only got included to try to recover some of the costs. I use these for embedding in 3D prints, where they work great. Just be sure to mark one end of each stack to show N from S if using hall-effect sensors.

Seem up to spec. Would buy again

Handy little magnets. Great for what I need. Quite strong too

Fent.

Moderate adhesion.