Anti Vibration Pads for Washing Machine - 4pc - Prevent Your Washer and Dryer From Walking and Reduce Noise - High Friction Hard Wearing Square Rubber Foot Pads - Universal Pedestals and Shock Support

Quality seems to be good but it didn't work for me and so I returned it. Washing machine vibrated a lot more after using these pads than usual. Felt like whole house is vibrating, so had to remove it and return. Not sure if its my wooden flooring and base which is on studs or something else.

Worst product

Update 2023-11-12: I decided to try these again after buying a front load washing machine and they are working very well. Prior to using these, I leveled the washing machine and didn’t have any issues with it walking or moving around, but the amount of vibration it created would cause everything in the adjacent room to vibrate as well. After adding these there is a substantial reduction in the amount of vibration. I have not noticed any additional shaking or vibrating after adding the pads. ———- Previous Review ———- This product did not work for my top load washing machine. I leveled the washing machine and checked it with a 4’ level prior to putting the pads in place. After placing them, I checked that all 4 legs of the washer were within the circles of the pads. I put a medium sized load of clothes in, making sure the load was balanced, and started the wash on a normal cycle. Once it got to the spin cycle, the washing machine began shaking and vibrating much more than usual. I stopped the spin cycle before it finished and removed the pads then resumed the spin cycle. The shaking and vibration diminished significantly. I am disappointed to say my washing machine is much quieter and much more stable without these pads. I bought the pads in an attempt to reduce the amount of vibration felt in the floor of the adjacent bedroom.

Fantastic! Machine vibrates but the pucks are steady, no movement at all. Highly recommend.

Always walked when machine was level. Floor had slight slope. The Speed Queen goes like heck, so the spin cycle was a walk-a-thon. Got the serious adhesive caulk, the $15 a tube stuff. Marked the feet locations, propped up the machine on 2x4s and glued these down. After 48 hr cure, these have held for two years and the machine stays put, despite nobody else being able to figure out how to balance a load of laundry. On bare tile, these alone were not able to hold in place.