Ethernet Wall Plate with RJ45 Wall Plate Connector – IP67 Waterproof Ethernet Wall Outlet for Outdoor Use – Stainless Steel Cat5e, Cat6 and Cat 6a Female to Female Bulkhead Jack

This Item is of good quality. It has a micro electronic connecting circuit. I Imagine is to use some of the Power from the RJ45 POE to strengthen the signal as it passes through adapter. I have not noticed any signal degradation. It comes with a mating connector so that it stays completely waterproof when you connect the pass through RJ45 jack

This Ethernet wall plate is perfect for our beach front bar. Network cable connection is fully sealed preventing any harsh weather effect on the copper connection.Unit comes fully assembled with pass through coupler, which makes installation fast and easy.

Looking for a robust outdoor ethernet wall plate, such as for low-voltage wiring of PoE cameras for example? Then you should seriously consider purchasing this device.That said, make sure you are aware of its constraints, and consider cheaper alternatives as this is by far the most expensive solution I've found on Amazon. Is it worth it? That depends on your needs. If it will meet them, then I would say yes.Pros: Metal faceplate, includes gasket, IP6x water tight (not waterproof), supports shielded ethernet cables, compatible with standard glands (makes it possible to connect these to standard electrical conduit).Cons: Interior connector is angled 90 degrees, expensive.My biggest concern with this device is the angled connector on the inside. Considering the fact it is a single gang size, unless you are placing this on the front of a deep junction box, managing to connect an RJ45 connector inside the junction box is challenging. If your cable has a strain relief boot, you will find it especially challenging and may need to remove the boot in order to avoid crimping the cable. This problem is worse with CAT6 and higher cables, as they tend to be stiffer.Overall, it is an excellent and well designed product.

used for outdoor PoE camera, working great

These are exactly what I was looking for. The builder installed in wall Cat6 that terminated in a 1 gang box.

Well it broke. Inside the wall it broke. Growl.

The waterproof feedthrough is too small in diameter and too short for use with overmolded shielded cables. Also, the 90-degree termination does nor allow that type of cable to bend tightly enough to fit in a junction box. It will probably work with more fragile premade cables that are not overmolded and not shielded, but I haven't tried that.

Very good stock. Thank you