Bath Repair Kit White, Endhokn Enamel, Porcelain, Acrylic, Fiberglass, Ceramic Sink, Tub Tile Toilet Shower Kit & Tray & Chip & Pedestal Crack Hole Scratches Repair

Easy to apply and finish. Color matched perfectly and it appears to be at least as strong as the unbroken original.One point to note is using the tape to mark off the repair spot. I was under the impression that the tape was to mask off the rest of the tub from the glue. Nope. I think it is for protecting the rest of the tub when you sand. I peeled off the tape and THEN sanded and roughed up virgin acrylic. Ended up putting boat wax on the scar and was all good.

This worked well to patch a hole in the bathtub. Prepping the surface was key and not using too much of the epoxy mixture worked best. We had to repeat the process as the first time, we used too much and the patch didn’t hold. We re-did it with much thinner layer and it worked fine. It is tricky to use as you have a time limit so getting everything organized before you start helps.

This product works, but it takes a little practice and skill to get it right. It works best on small areas, not so well on longer cracks.

Works well. Looks great. I dropped a small hammer in the sink….big divot and crack. This product is excellent. Clear directions, easy to use. Finish up sand paper was ok used some from hardware store to finish up. Looks great.

I was very cautious about following the instructions on this product. Even with the poorly written English description, the basic steps were comprehensible. I applied this product, allowed it to dry for three days, and sanded it down, wiped away the debris, and then applied a 2nd coat. After three days, i sanded it down again to a smooth finish. It looked good and seemed like it would do well. A month later and the product started to peel upward and flake apart. After about two months, the entire applied amount has flaked off and washed down the drain.After posting the review above, the company reached out to me to share clarification on the instructions, as shown below; and also refunded me for my purchase. I have not had the time to re-apply, as the process takes almost a week to get two applications. I adjusted the rating from 1 star to 3 stars because of their response (i did not contact them to request anything; they took the initiative to restore good faith). I wish all companies that sell Amazon products were as proactive about maintaining good customer relations and improving their product instructions.[company response]I am very sorry to receive your feedback. After mixing the bathtub repair kit 1:1 evenly, wait for 24 hours for it to solidify. Then, for any spilled parts, we recommend using stickers to protect the surrounding area before use. After the repair is completed, remove the stickers and clean up any residue that spills outside the stickers in a timely manner. This can greatly avoid damage to the repaired surface caused by polishing. In addition, after application, a scraper can be used to help smooth the surface. On the one hand, it can promote penetration and bond more firmly. On the other hand, it can obtain a smooth surface without the need for further polishing. Because we know that if the polishing is not thorough enough, the glaze will be damaged, making it easy to be stained and accumulate stains. If the surface is polished smooth enough, it means that the cured bathtub repair paste may have been polished to a minimum, and the adhesion will decrease at this point. If the area is frequently washed away by flowing water, the already thin surface will become more fragile, leading to peeling.Therefore, in areas that are frequently washed away by flowing water or affected by external forces, it is recommended to apply as thick a coating as possible, as this area has a higher frequency of use than other locations and is more prone to secondary damage. At the same time, we will also provide a full refund. For the remaining products, you can try again according to our suggestions and do not need to send them back to the Amazon warehouse.

There was a small crack in the bathtub and this patched it right up. Very easy to use. I did two coats, allowing the first one to completely dry. The total epoxied area is roughly the size of a 3x5 card and I still have about half the product left over.I found the included stickers tough to use, not enough to fully surround the area, and realllllly tough to see - so I just used painters tape and that worked perfectly.Dries bright white. My tub is more of an off-white/ivory, but this doesn’t stand out too much.UPDATE: Used a bath bomb and the patch is dyed purple now! I still think it’s a good product for the price and purpose, but definitely be aware that it won’t stay white.

Very easy to use and fixed the hole in my tub completely, and cost-effective at that! You can even look up a video that walks you through the process step by step.

Yellows over time. Went on great. I thought I saved myself from having to buy a new sink/countertop combo due to cracks in sink. Applied this product as directed. It looked great when I finished. Was very pleased. HOWEVER, this product is now yellow and makes my white sink look dirty and old. It will take much more effort to repair now.