EaseLife 5.5FT Bypass Double Sliding Barn Door Hardware Kit,Single Track, Slide Smoothly Quietly, Easy Install， (5.5FT Track Kit for Double 38" Wide Door)

Worked great. Easy install.

Very easy to assemble. Quick install. Nice quality and coating. Glide easily. We used a header board. Needs to go up another 1/16 of an inch at least to get the floor door guide on..We have to do some adjusting. Beautiful, just what we wanted. Be sure and allow for the overlap of the doors. I bought 36" doors and wish I had bought 40 inch doors (opening 67". Doesn't cover my trim which is my fault for incorrect measuring. Nice quality. Recommend

Awesome! Project turned out great they look and work very nice

I installed the track and couple days ago and it went smoothly, I liked the rollers and hardware but I thought the 8 ft 2 piece hollow metal bar might be a little light, time will tell. Also the right stops had a stript Allen screw, over all I think it's a good product and as I said the rollers and hardware are impressive.

Pretty easy to put up. Looks great with the barn doors my husband made

Great quality and price. Easy install too. Looks great!

I shopped around for the right hardware, as I was working with a tight space. Dimensions needed to be spot on. I decided to go with the single track as it’s a much cleaner/slim look. The hardware is top quality and looks super high end.Installation tips (single track only)- Move the hangers as far to the each door edge as you can, if you are looking to maximize space when opening each door.- The door thickness I had was approx 1.5 inches. When you install the hanger bolts you may need to cut them to length. I purchased a cheap hand grinder to cut them, you could also use a hacksaw (which is a bit safer). You will know if you need to cut the bolts as the other door will hit the bolt.- I used a hand grinder to cut the the steel roller bar. Again you could use a hacksaw.- This tip should help out quite a bit. When I considered the weight of the doors, I felt strongly that the lag bolts supplied were not sufficient to hold up the doors ... safely. I would be worried about the lag bolts coming loose and at least causing a poor movement, at worst the doors falling off the rail and causing a lot of damage.I decided to add a header board in the front and in the behind the wall. So I had 10 inch bolts connecting through the wall to really hold the doors and rail system up, and boy did it feel solid.Tools I used:Hand grinder with cutting wheel5/16 all threaded bar, cut at 10 inch lengths for all five holding positions.Spring washers and large 1.5 inch washers to secure bolts in place, for the 10 inch boltsRip saw for cutting header boardsCorse 2 inch screws to install header boards to drywall. Making sure you hit the studs. Tip, if you have a wall where you do not have enough studs to work with, predrill the holes and use anchor drywall supports.Hope all this helps. It took me a good two days, to install correctly.

Nice weight to hardware...be sure to save the instructions...kinda confusing