JETech Screen Protector for iPhone 6 Plus and iPhone 6s Plus, 5.5-Inch, Tempered Glass Film, 2-Pack

There are two tempered glass protectors which come as part of the pack. It also comes with screen cleaners (cloth), dust removers (sticky pads), and guiding sticky pads.Fitting the protector is straight forward and easy , which took 10 minutes maximum. You clean the phone screen with cloth, followed by the removal of any dust or bits with the sticky blue pads. The guiding pads are placed on the tempered protector, before the adhesive protection film is removed. You then align the tempered protector with your iPhone screen and gently place on top. If necessary, any air bubbles are gently pressed out easily by rubbing the screen. The air bubbles appear far less than when using the cheaper, film alternatives, and when they do, they are much more easier to press out.All in all, a quick and simple job. The functionality of the touch screen isn't affected. The only way you can tell the protector is on is by looking at the small gap between the edge of the phone and where the protector stops. (This is to allow allow all phone cases to fit).I would definitely use again, and would look for the same for other device.

Exactly what I was looking for and at a good price.

Good quality

I have used a few of the thin plastic screen protectors and developed a system for fitting them which avoids the dreaded air bubbles. This is the first time I have tried a rigid glass protector. There were two protectors supplied together with instructions on fitting but I thought the way I have developed for fitting was better so used that. The result was a good easy installation with no air bubbles. The protector has proved to be easy to clean, resists damage and gives a nice easy glide surface on the phone. First impression is that these are better than the plastic ones.Forget the instructions and fit as follows.- Clean the phone screen very carefully. I use a little washing up liquid, rinse, dry and then polish with the supplied cloth- Place the protector on the phone and hold in position with a couple of elastic bands- Slide he protector until it is positioned in exactly the right place and then stick it down along one long edge with sticky tape- Optional step. Go to bathroom and run shower until it is steamy. This helps to settle dust in the air.- Remove the elastic bands and lift the screen protector using the sticky tape as a hinge.- Remove the INSIDE protective film for the protector and carefully hinge it back into position- Rub the surface to remove bubbles which is easier than with the plastic protectors.- Remove the outer protective film and the sticky tape.

Product is size perfect for a 6S+ and I like the screens low profile. It is thinner than others I have tried before.As with most things in life preparation is the key to success.The best results are achieved if the host screen is thoroughly cleaned AND the sticky dust remover (provided) is used to catch traces of loose particles that find their way onto the cleanest of screens.I have a template, from a previous replacement screen kit (B00OK8QPF2) which slides onto bottom third of the phone allowing the new screen to align simply and quickly.If you have one of these, the application will be made much easier and ensure a fit first time.Maybe JETech would consider including one?When in place, the quality is immediately noticeable and there's no loss of sensitivity. Adhesion is excellent and because of my preparation, no bubbling from trapped air and or particles. It's a seamless fit.Photo of screen applicator attached to this review for the benefit of those who require alignment assistance.Very impressed.

Fit really well & easy to apply. Thankyou!

These screen protectors come with a good kit to apply well. Cleaning cloth, blue sticker to remove lint and 2 clear holding stickers that you apply to the corners of the protector to help you guide where to place the protector.The main downfall is that it is not true size.There is 3mm-5mm gap around the edges leaving the edges of the phone exposed to damage and unfortunately even with a bumper case with raised edges... still is not complete protection...(previous damaged screen because of this)I will be on the search for a better long term protector however this is a pretty good value protector for the meantime until I find one that fits to the edges. Delivery was quick and Sellers packaging was good

These screen protectors are the best out there, and I won't use anything else. Gone are the days of struggling to put a protector on, line it up etc only to find a speck of dust ruining the application completely. This two pack has everything needed for two full, separate applications: Protector, cleaning cloth, dust removal sheet (which are genius in themselves) and sticky tabs to line things up perfectly. On placing the protector in position on your cleaned screen, it just 'grabs' and applies itself.If you follow the instructions provided, it's foolproof - as proved by a fool like me who can get a new one on perfectly in minutes.This protector replaces one the same that has been on my phone for the last sixteen months. I'd dropped it and bashed it a few times, and the protector itself had a few dings in it. The main thing of course is that it properly protected the phone underneath, and for the money, you can't go wrong. Being a two-pack, also means that I have a replacement for this current new one should I need it.On ordering this for my 6s Plus, I also ordered the same for my daughter's 6s 4.7 screen, and all arrived the following day.Quality product from a reliable seller. Nuff said...