INJORACarbon Fiber Chassis Kit Low Center of Gravity Frame Girder for Axial SCX24 Deadbolt JLU C10 Bronco 4Runner 1/24 RC Crawler Upgrade Part, 15g

Great price, awesome looking upgrade. It’s light weight and because it’s carbon fiber it adds at least 10+ hp to your SCX24. It fit very well and there is lots of ways to set it up to fit your needs. Very cool to be able to adjust the shock mounting points. It’s a great option for some like myself just learning to build my own because there isn’t so much adjustment points that it is overwhelming.

Takes a bit of tinkering, running backwards requires some creativity to line up the holes. Good mounting option. I ran it normally and managed to swap out without pulling the car apart very much. Mounted to an scx24 without issues. Reversed it to get the battery up front, a fair bit more challenging to get everything tucked in.Pictures are with as many suspension mods as possible, couldnt get it lower. Afterwards its much lower.Noticeably more planted than the stock rails(as it should be!)Single picture is with 1.3 injoras.

I have a Bronco SCX24 built almost entirely with injora parts. For the incredibly low price, it is an absolute BEAST. However, I have a few tips for this chassis.1: Get longer shocks. In most cases, a build won't benefit from shocks longer than roughly 43 mm, unless the build has serious modifications. If you're using the stock chassis and links, 43 is the absolute limit. With these, 43 is almost a minimum if you're trying to run a stock body. It sits so low in relation to the wheels that a lot of your rebound travel will be taken up just to achieve ride height. Get longer shocks to compensate.2: Have some magnets handy for body mounting. They'll help a lot. Use 3m VHB double sided tape, it's the absolute best and it's crazy thin.3: My build has the injora steering link, and EMax servo. At full compression, the front of the chassis hits the bolt that links the steering rods. Trimming about 2mm off would fix it.4: It will take A LOT of patience to get a stock body to fit, and probably a lot of trimming.

frame is great only complaint is the shock holes aren't threaded so you have to put a nut on the backside of the screw holding the shock in place (the nuts are tiny and hard to deal with). other than that the frame meets or exceeds expectations!

Easy to install if you know what your doing. Great price. A works great. Chassis is lighter than stock!! Fit the b-17 Betty great!

Injora quality

Budget friendly, great LCG Chassis for the price angled skid multiple shock mounts and easy to put together.

Works really good on my scx24. If your using a furitek motor then you want to get injora's side plates they make for your esc and reciever.