RX WELD Nitrogen Regulator, 0-800 PSI, CGA580 Inlet, 1/4" Flare Outlet

RX WELD Nitrogen Regulator with 0-800 PSI. Impressed by quality of machining on this unit. Had inlet filter on inlet to tank which was nice to see. High Pressure gauge have increments of 125 psi which is suitable for gauging supply tank pressures. Low - Supply Pressure gauge have increments of 20 psi, with zero pin and 20 psi being almost the same. This regulator might not be suitable for someone needing a quite low pressure output for very low flow work. It worked fine for supplying my nitrogen flow meter at 60 psi, as well as supplying 400 psi for a pressure test I performed. The gauge to tank inlet stem could be a bit longer so the gauges would clear the tank knob on a 125 cu ft Nitrogen tank when attempting to install the regulator with gauges in a straight up viewing, but it worked perfectly fine when rotated a bit to clear the tank knob. It just made viewing the gauges a bit unhandy. Hose supplied had a white plastic type gasket and worked fine for my work.I found after using this regulator with a 125 cu ft Nitrogen tank that the inlet stem of the regulator should be at least 1 + inch longer to allow clearance between the tank knob and gauge set. This would allow the gauges to mount vertically and Nitrogen Flow Meter if attached to hang vertically as it is intended to be used. I have not tried on a smaller 80 cu ft Nitrogen tank, but hope the smaller tank size will allow for adequate clearance so the Regulator will mount vertically.

These works wonderfully

This Regulator is built tough.I've waited for almost a year to review, and I have put it through hell and back. I'm an commercial HVAC contractor and we use it everyday on the jobs items. I actually still keep the Regulator in its original box it came in when not in use.

Works fine. This connects to a high pressure inert gas cylinder, like argon or nitrogen, and outputs to an HVAC flare connector for a test hose. Used to pressurize an AC system's line sets for testing before charging. Works fine for that. Note that this is a single stage regulator, so it's going to bounce high a little bit as it flows gas. So hook it up and start low, and then ease it up to the pressure you really want rather than just set it at the high point and connect and turn on the tank valve. Otherwise you risk over pressurizing your system and breaking things. That can happy with ANY single stage regulator, it's the way the design works.

I have been using these gauges for two weeks and so far so good 👍.

Works wellRugged

Good price

Great value for the money.

Me ha salido muy bien el manómetro,tengo unos meses usándolo y todo bien,lo recomiendo,llegó bien y empacado perfectamente

If I could GIVE "0" i would, this regulator never worked properly. Tank gauge was always stuck at 200 psig, never went higher. I checked with 2 other Nitrogen regulators that i borrowed from my friends and those showed 2000psig. Btw another buddy told me that he bought exactly the same regulator from this seller and had the same issue. So it must be a MANUFACTURING DEFECT that they don't want to fix or cover. I realized it past 30 days of return policy and now i'm stuck with this GARBAGE. Stay away from that seller and product, they don't have a phone number where you could call, and if you chat , they just redirect you to Amazon. No support, no customer service , they are not liable for anything , imagin if it leaks.

I did not receive the all package, the hose was missing