25 Inner Fender Push-Type Retainers GM Honda & Mazda

I bought this retainers for my wife car, a 2010 Mazda 6. The original retainers broke after some time and I need to replace the ones holding the fender liner, this are as good as OEM, you can't go wrong with it and for the price is a steal.

Quality looks great and I don't have any problem using them. These retainers were slightly bigger than what I expected so they didn't fit, but I think I mistook it for the name "inner fender" but I think I was looking for something else like wheel well, engine covers, etc. I will find where these should go and they'll do great.

As far as plastic retainer clips go, the quality of these clips appears to be better than what you might buy at a auto parts shop and they cost far less, so they get a good rating from me, BUT, they are not the right size to replace the exterior clips on a 2011 Mazda6, and I could only locate a couple of clips inside the trunk that appeared to be a similar size (though these did not need replacing). Since these were one of the most featured clips I found listed a being for a Mazda, I purchased them, but so far have not found a use for them on a 2011 Mazda6. A better description of where they fit would be helpful. If you are looking for exterior clips for a 2nd generation Mazda6 (2007-2012) then you need 8mm hole diameter, 9mm stem length, and about 20mm head diameter.

Good Price, Great Product, Fit perfect for my 07 Mazda 3 with no problems

I have been looking for clip retainer to fix the splash shield underneath the 03 Corolla. I decided to buy these because of the description saying "fit Toyota because of 7mm hole". Well, these did not fit, their size are too small for 7mm holes. They went thru the holes too easily and did not hold it tight enough for the road. I gave 3 stars because the quality looks good, and fast shipping too. However, if you are planning to use these on 7mm holes of Toyota, these won't work per their description. FOLLOW UP: I measured the retainer, it's 6.5mm. That explained the way it went into the 7mm hole on Toyota. If your car has 6mm holes, this is the product for you.

Needed some replacements retainer clips for my car. These did the trick worked as they should.

100% do not recommend. Loose when installing into fender well. Came out while on the freeway and my fender well liner got shredded by my tire.

Have a bag of these on hand. Jap cars use these all over the place, and they break or fall out over time. Fits a lot of the fender parts on Mazda 6.