32.8ft(10M) 24V COB LED Strip Light Natural White 4000K 3840LED CRI 93+ 6800lm Uniform Glow Dotless IP20 Not Waterproof Flexible LED Tape Lights for DIY Bedroom Home Decor(No Power Supply)

This LED light strip was very easy to install and much brighter than I anticipated. I have these lights installed around my laser bed, and goodness I’m glad I purchased these. Simple 24 volt connection and the adhesive tape sticks really well.These are well worth the money. I would purchase again.

I used this strip to illuminate my vaulted ceiling. I particularly did not want to see individual bright spots, as I wanted a more even look. This LED strip worked perfect. it came with leads on both ends, which came in handy, because I ended up cutting the first leads too short for my install. It was helpful to unspool the strip and have two more leads on the far end to use. The only issue I had was there was no scissor mark as to where to cut the strip. Instructions state every 30 mm, and I ended up cutting on the small dots found at the middle of every copper contact along the strip (last photo close up).

This LED tape is the perfect brightness for my application. I used it for lighting my workbench from under a shelf above the bench. At 24 inches away, it is more than enough light for detail work, and the color very closely matches the daylight coming in a nearby window.I have the tape mounted in an aluminum channel with no diffuser, just for the heat dissipation. There isn't a huge amount of heat, but the channel does get slightly warm.I have powered about 2M of tape from a 24V power supply, and it pulls just over 750mA, so I would estimate about 400mA per meter at 24V.

I used a portion of this strip to provide internal lighting in my new 3D printer. I simply cut it to the needed length with scissors and attached a lead to plug it in to a 24V power source and it lights up exactly as I had hoped. The backing on the strip worked well to attach it to the inside frame of the printer.

The media could not be loaded.  Using this type of light requires a lot of research I.e how many watts does it consume , volts and what kind of driver will work , what if you have 150ft to install , can this be hidden behind the crown mounding …. Etc. etc . I this the seller needs to provide like other compatible items that this could work with. Since I did my own Research I ended up with a large driver that cannot be hidden and also I had to by a remote control dimmer too that would go with the driver. So all in all this costed me like $175 for 1 room with 45feet rope lights. I must say the brightness is excellent. Just what I wanted

Using to back light new gauge panel. Only one 19" strip so far.

I bought these to use with my printer (Bambu Lab) and am pleased. I have a dedicated supply with an on/off switch for it and it works well. Very happy with it.

This is at least what you would expect from a good quality 24v COB led stirp if not better.The solder pads are good size so when you cut the joint there is plenty to solder either side of the cut.The LED's are very bright, to the point where I used a buck converter to turn the voltage down a little.I would say that the primary image for the LED's does not do them justice. If you want a bright, white LED strip where the LED's are not generally visible, there are a very good choice.