Mount-It! Low-Profile Large TV Mount | Flush TV Wall Mount | Ultra-Slim Fixed TV Mount for 42-70 in. Screen TVs | VESA Compatibility up to 800x400 | 220 lbs Capacity

Fantastic! It's wide enough, and includes enough hardware, to bolt up to three studs. That's hard to beat, for sure. I'm using it for a heavy 70" TV and have absolutely no concerns or qualms about my expensive television being perched on this piece of hardware. The ability to lock it with a padlock is an additional plus, adding a layer of security. And it's 'locking bar', even if you don't use it with a padlock; is an easy way to secure the television to the mount so it can't be easily lifted off or 'bumped off' of the mount.The included hardware is decent. Not the greatest, but plenty good enough. Since they are pretty large lag bolts; I'd recommend using a socket and wrench to install, rather than a powered driver (like a drill/driver) to prevent cracking studs.Packaging and instructions are sub-par. The instructions are useless. But then, it's fairly self explanatory. Just make sure you have a plan of attack before you begin putting things together.I'd buy again!The picture shows my mounting setup, with wires hidden inside the wall. Looks great! And I figured I should take the pic with the TV on, and so enjoy a still shot of a little 'Alaska State Troopers', which happened to be on when I fired up the set!

I needed to mount my TV in a place where there is a wall stud pretty much dead center of where I need the TV. If I were to mount my TV on a swinging arm with one fixed installation point this might work, but I don't like the idea of a hinge mount for a big TV. The length of this mount allows me to offset the centering of the wall mount between two wall studs that are 24" apart, and to align the TV where I need it to be.Basically, I fixed the right end of the wall mount over the right wall stud, and the left side of the wall mount went several inches past the left wall stud. I was then able to hang my TV toward the left end of the wall mount, and this centered it perfectly over my shelf (moving the shelf itself was not an option here). You can see some of the wall mount sticking out to the right side behind my TV, but this is a complete non issue for me as it was more important to center the TV.The wall mount and brackets that attach to the back of the TV seem to be of good quality, and the hardware (screws and bolts) have given me no issue. So far everything is holding up, and it's clear that this mount could hold a TV far heavier than mine. I'm confident that it will hold mine until it needs to be replaced and couldn't recommend this product more.

**Likes**Slim mount , made my Oled c8 almost looks like its just floating on the wall.Easy to set up and wide enough to be able to find wood studs to properly secure the mount to.**Dislikes**the locking mechanism , im not sure how that works and the instructions included had no clear information kn how to use the locking mechanism. Its supposed to work with a padlock. I never figured that out.Another thing id like to say is this mount has no tilt.If your looking for just flat on the wall with no movement or tilt while maintaining a very low profile. This is it and its cheap !

Good product. Built well and easy to install. Do not rely on the built in level bubble do yourself a favor and buy a torpedo level. My TV would have been over an inch left to right out of level if I didnt use a different level. The measurements of 800mm x 400mm are spot on and not much wiggle room. I have a 55" LG and it maxed out the 400mm (height)adjustment measurement. Has 3 different notches for moving TV up and down the on the wall in 2" increments which is nice.

Works great for my 65" plasma TV, which is quite a bit heavier than most of the LED LCD and OLED models out there. Hugs the wall very closely for a nice look.The bracket's wide bolt holes came in very handy as well due to the weird spacing of studs in the wall I needed to mount the TV on. That's actually the reason I bought this new mount - my old one's bolt holes were too narrow to fit the studs I needed to drill into.Anyway - I highly recommend this mount, especially for large and heavy TVs. Do yourself a favor and do NOT spend $70-100 on the mounts sold at big box stores. If you're just looking for a basic low-profile mount and don't need tilt/swivel functions, then this is the one for you.Instructions were somewhat sparse as I recall, but that's not a negative thing as far as I'm concerned. If you can't figure out what to do with the pieces, you probably shouldn't be mounting the TV yourself anyway. Call in a professional or consult YouTube!

Got this mount for my 65” Vizio. I was mounting it low enough that I did not need a tilt feature.I was drawn to this mount because it was a solid piece that did not require assembly and the height was easily adjustable. The length also makes it easy to slide the TV side to side to center it horizontally.The metal for the arms and wall mount is pretty thin, some of the ears were bent on arrival.There are not holes in the middle of the mount as shown which meant I couldn’t hit 3 studs when mounting.The line of holes was also crooked and not parallel to the top of the mount, so make sure you level off the top of the mount.The arms grab the mount in 2 places and self lock with gravity, but the TV can be removed by lifting up.The locking bar provided was a little cheap. Came with a level and HDMI cable which were not used.Overall a decent mount, wish it was a more heavy duty and the holes were cut straight. Can probably get something better for the money, I’ll likely buy something different for my downstairs TV.

Replaced a 65” with a new 77” OLED and was unsure if mounting bracket in use was wide enough. I ordered this just in case and glad I did. It’s double the size of old mount so it allowed precise centering of massive TV. Super easy to install in studs on both sides.

Llegó antes de la fecha estimada, viene con todo lo necesario para una instalación completa, el único detalle es que el nivel que viene incluído no es muy confiable

Used this to hang a 100# plasma TV. Works great and simple to install.

Efectivamente, permite prácticamente montar en la pared la tele, ya que su separación con la pared es de máximo unos 5 cms. Lo que sí es que eso complica colocar los cables, pero tampoco se está colocando cables a cada rato.

More than adequate to mount a 65” Samsung.

Fonctionne parfaitement