IMC Audio Double Din Dash Kit for Aftermarket Radio Installation for Acura RSX with Wire Harness

Will not fit no name brand car stereo. Got a DRWW radio and it will not fit. Brought a pioneer and it fit perfectly.

Easy to install fit perfect

Grab 2 small washers, as long as your screw fits through the washer and the washer isn’t bigger than 2inches you’ll be fine. What you need to do is put a washer between the plastic and then screw in as far as you can go (NOT TOO TIGHT, JUST TIGHT ENOUGH) and the hazard lights will function properly.Other than this fault, it looks great and upgraded my RSX interior immensely. For the price you’re getting a flush kit and the wire adapter, pretty good deal.

Received but missing wire harness. Really didn’t need as you remove your stock housing and screw it right on to radio. Really needed harness and was not with package.

It was missing one part but didn't use those two parts on this install.06 rsx dual brand double din non cd DVD headunit. Ignore the instructions. Prepare wiring harnesses with solder shrink-wrap or butt end connectors. Set aside.Pull plastic panel off above cupholders with cigarette lighter off using a small flat blade. Set that aside.Use 8 mm boxes or 1/4 drive ratchet and short 8mm socket to loosen two 8mm bolts under stereo.Push on the metal bracket attached to the factory headunit with some force to push it out of the dash. It might be rather difficult.Disconnect hazard button wiring.Take the old bezel, headunit, and storage compartment out of dash.Take metal bracket off factory stereo and bezel. Retain screws.Remove hazard button and retain screwsCompare the factory bezel and the bezel in this kit notice the plastic tabs on the bezel In this kit are way to thick for the metal retaining clips. Shave them down with a file or dremel to proper thickness.Remove metal clips one by one from factory bezel to new bezel. Squeeze / spread / adjust as needed with pliers to remove and attach to new bezel.Screw factory metal bracket onto new bezel.Set head unit in metal bracket, notice to get the holes on the headunit to align, new slots, holes will have to be cut or drilled and mark for Dremel cuts. Small washers might be needed.Remove metal frame from new bezelDremel holes / slots.Put metal frame and bezel back together,Put headunit in place, the four machine screws that came with the kit, screw the head unit into the metal frame. You may need some small washers here.Most important part, Dremel cut off wheel, or sanding drum the back part od the hole foe the hazard button or use a small stack of washers on each of the two screws for the hazard button. The purpose of this is because the depth of the bezel plastic around the hazard button is too deep and causes the hazards and turnsignals not to work. Stacking some small washers or dremeling the back of this hole down corrects the issue.Toss everything together. Test everything. Pat yourself on the back for a job well done. Enjoy.

It works and fits but rhe way the part that holds the radio snaps to the face place is pretty crappy but hot glue or superglue will fix that

The size does not fit, I had to file it down so much in order to get it to fit, a lot of time invested and the whole appearance looks cheap afterall.

Fits perfect with my Rsx only issues I had was the thin plastic that came with it was broken due to shipping so I tossed it in the trash and contacts the seller to see if they could send me out just that thin piece. Product was great tho