Buck Mark Picatinny Scope Rail Mount

Well made, easy to install, comes with the screws needed.

I had the same rail for the buckmark but with the built in rear sight. Unfortunately that one did not accommodate the full length of the C-More Railway red dot sight. So I had to swap it out. Drop in fit, no fuss, well machined, good hard finish, and no interference to slide function whatsoever. AND it fit the C-More Railway perfectly... mission accomplished.

Excellent low cost sight rail.

Mounted this on my Buckmark. Easy install. Works as designed. Makes it look like something Han Solo used with accessory mounted.

The rail is well made and it fits my Buck Mark Camper with UFX grip perfectly. I also like that it came with its own pair of screws and they don’t need the star washers that are required for the original Buck Mark sight base. After half a drop of blue Loctite, the screws stay put even after a few hundreds rounds during range visit. It is expensive and it doesn’t even come with an iron sight, but my scope fits on this base nicely and it is very accurate to shoot with a scope. It greatly improve my groupings at 15-yard distance. Buck Mark is fun without the scope, but it is super fun with it. If you are on the fence, hope it is helpful for your decision making.

Bought this for my Browning BuckMark Camper to put a BuckMark Red Dot for picatinny mount. The two holes were in perfect alignment! I’m a happy camper!

Easy to install and a perfect fit. I read elsewhere that folks had to drag the mounting holes with a drill. This was not needed and may be the result of an incorrect mounting procedure. The barrel is held in place by two screws, one on the front of the frame and the other on the top of the barrel. The first screw must be loosened to allow the barrel screw hole to align with the rail. Before doing any drilling, examine the original sight rail and compare it with this accessory rail. The holes should be the same distance apart. If they are, don't be drilling anything. You'll degrade accuracy.

A bit pricey for what it is, but the Picatinny rail for the Buck Mark pistol is well made and works perfectly. Installation was simple and intuitively obvious. I bought a similar rail for a Mossberg 590 recently for a little over a quarter the price and it was almost as nice, so I started to deduct a star for value but I didn't because the high quality justified the high price in my opinion, and it was worth the price to mount optics on my Buck Mark pistol. I have a tiny Vortex Venom red dot to mount, bit so far I've been playing with a little green Crimson Trace laser and that's a lot of fun too.