onlyfire Universal Rotisserie Kit 32”- 42” x 5/16” Square Spit Rod for Use with 2 to 4 Burners Gas Grill | Fits Most 2 to 4 Burners Gas Grills, 32"-42" x 5/16" Standard Square Spit Rod

Works great, but haven't had it long enough to see how the motor lasts. The joints of the shaft are not preferable but I understand why it was made in pieces for shipping reasons. Lots of differen't baskets that can be used on it, so it's very handy.

Works like a charm, and it’s heavy duty

This Rotisserie arrived on time and well packaged.Its a universal -I dose fit my Nex grill. So far its handled chickens and Pig tenderloin no problem.The Tongs are complementary size.I advise not to leave the motor out in the weather as it will go bad. A good buy for the money.cleaning is a little difficult as the shaft is in multiple pieces.Properly taken care of and cleaned this rotisserie will last for yrs.

Really great buy- will make rotisserie barbecue very easy! good quality materials as well. would recommend to buy!

So first off, the supplier has not read all the reviews because my rotisserie also came missing one set of mounting hardware. I read the reviews prior to purchase so I was prepared. Also, the 2 sets of prongs do not slip over the connecting nuts, but it is not really that big of a deal if you prepare. I wanted a rotisserie that could be used with a charcoal grill. Having already purchased this pictured grill, I decided to make it work with it. My installation does not allow the dome lid to be closed during cooking, which isn't how cooking over an open flame should be anyway, but it allows me to continue to use the grill as it was originally designed. I installed in just under 20 minutes. I used self tapping sheet metal screws, a drill with a very small bit just to get the holes started, and a screwdriver. A level to make sure the spit rod was even and that is it. As you can see, it fits and it works just fine. To address the other issue about the nuts backing out (loosening) during cooking, you have two options of which I did both. First, use two 5/16 wrenches and tighten the rods tightly together. Also, if you turn the power off/on it will rotate in the opposite direction which keeps the threads tight and not allowing them to back out. I do recommend the supplier talk to the manufacturer to make a few changes like adding two sets of hardware, one for each side for those that need it. They should also make the inner diameter of the spit tongs big enough to slip over the adapter nuts.