Bearing Separator Puller Set,5-Ton-Capacity Bearing Separator Kit with 2" and 3" Jaws,Bearing Splitter Remover Tool Kit,Wheel Hub Axle Puller Set

Great price and quality

Pullers are good quality. I used them to remove bearings from mower deck spindles.

Easy to assemble and use. Great tool for the money

Unit comes in a nice case. All parts fit case recessed areas nicely. Actual bearing puller halves and standoffs are good. The nuts are low quality Zinc style. I went to a hardware store and replaced them. They are metric. The washers were absolutely terrible. All of the washers had sharp edges from when they were fabricated. Sharp enough to cut your fingers. Washers are mostly fabricated by punching the washer out from a sheet of metal the thickness of the washer using a set of hardened dies. This is why on side has rounded endives and the other is not rounded. From use the dies wear eventually out and the edges of the washers get sharp edges and when the dies really wear out the edges actually have stretched fingers of metal as the metal tears because it is no longer being cut by the punch dies. Had to sand all washers on the bottom and sides. Took a long time. Also greased all threads and new nuts. I would have returned the tool but I was already in the middle of greasing everything. I’d recommend buying from another vendor. If the washers and nuts are such terrible quality are the others parts actually good? Made in China.Oh and the replacement nuts cost me $15.54. If I replaced the washers it would be another $5.00. So it’s not a good deal if you actually use the tool for its intended purpose.

Don’t waste your money and time on this puller the puller jaws are incredibly soft, they started to bend trying to pull a bearing off a small pump shaft. Immediately returned it. You would be much better off getting a puller set from OTC, those are actually worth the money.

Snapped trying to remove the hub from my wife's powerchair.

⭐️⭐️⭐️⭐️⭐️

Very handy tools gets job done easily

Very Good