Front Footpegs/Footrests/Pedals for kawasaki ZX-6R ZX-9R ZX10R ZX636 Z800 Z1000 Z H2 ZZR1400 ZX14 ZX-14 (Front Pegs -Black)

Didn't get to use them because my bike was totaled in a crash (I'm good wasn't hurt)... but the pegs did arrive on time and look well made and from good material

For right on my BMW k1200rs. Gives me a couple of more inches of leg room to not be so cramped up.

They're very well made but I'm not sure why they go out of their way to call them non slip when they are about as smooth as it gets. They have machined channels in them that let the water run off but the surface is generally flat and smooth. They are otherwise well made with excellent fit and finish and seem to be of good quality but no slip they are not.

Oem fit. The end pieces that are supposed to screw into the ends and stick out may not fit. Not a big deal but one of mine didnt thread into the hole.

Used in the track and street. Ok quality. Recommended. Purchased twice already

Fit fine had everything there except it springs don't sit eith the hold right so I had to use the oem one

Nice and easy to install

I ordered these for my 2025 kawakaki KLR 650s. They fit perfectly! They are longer than the stock foot pegs which is a definite plus. Very easy to install. The snap ring on the stock klr can be a little tricky. They look great with the gloss black paint and provide much better grip than the stock foot pegs. Defiantly a great value!

⭐️⭐️⭐️⭐️ Good Upgrade for the Price (With a Small Caveat) I finally got around to installing these on my 2025 Ninja 500. Even though the 500 isn’t listed, most Ninja 400 parts mostly fit, so I took a chance, and they do fit without any major issues. Installation was fairly straightforward, but I do wish the kit had included new C-clips. One of my OEM clips snapped when removing the stock pegs, which isn’t a dealbreaker, but it would’ve been nice to have replacements included. In terms of quality, these are decent but not comparable to the original OEM pegs. That said, they’re adjustable, non-slip, and look great on the bike, especially if you’re just looking to change up the appearance or refresh worn pegs. For the price, they do the job and look good doing it. I’d recommend them as a budget-friendly upgrade, just be prepared in case you need extra clips on hand.

These foot pegs are beautifully machined and hard anodized in black. They have a hig-end look. The pads are a bit longer and wider than the stock pegs. Exact dimensions are shown in my photos attached to this review. The bolt attachment between the fork and pad is a really slick way of adjusting the peg angle. I think these look great and will add a touch of flair over the rubber and steel factory pegs.