💧 Stay Dry, Stay Smart! Your home’s first line of defense against leaks.
The 12V DC Wired Water Detector is an essential tool for any security system or standalone water monitoring setup. With a maximum load of 10A and a built-in 80dB buzzer, this device not only alerts you to leaks but also automatically shuts off your water supply to prevent damage. Its adjustable sensitivity ensures accurate detection, making it a reliable choice for homeowners.
| Contact Material | Rhodium |
| Contact Type | Normally Open |
| Current Rating | 10 Amps |
| Brand | Tokatuker |
| Operation Mode | Automatic |
| Coil Voltage | 12 Volts (DC) |
| Contact Current Rating | 10 Amps |
| Maximum Switching Current | 10 Amps |
| Maximum Switching Voltage | 15 Volts |
| Minimum Switching Voltage | 1E+1 Volts (DC) |
| Number of Terminals | 2 |
| UPC | 750225419018 |
| Manufacturer | Tokatuker |
| Item Weight | 3.2 ounces |
| Product Dimensions | 3.23 x 1.97 x 1.26 inches |
| Color | White |
| Voltage | 15 Volts |
| Sound Level | 80 dB |
| Measurement System | Metric, Imperial |
| Batteries Included? | No |
| Batteries Required? | No |
S**2
Works Great as Safety Device
I used as water detection device for the overflow drain pan on my Air Conditioner. This will detect even a small amount of water and I have it wired to turn the AC off if water is detected. It has a much quicker response than the standard mechanical float system.
T**Y
Great for remote leak monitoring
I do a lot of remote monitoring of water treatment sites (pump stations, RO facilities)... and leaks are an important thing to monitor. This unit will provide an audible alert when a leak is detected... it also has a relay with NO and NC dry contacts that I can easily connect to my gateways for remote monitoring and alerting. I like that I can adjust sensitivity if I need to. Easy to test it with the type of water that you are working with. 12 VDC power requirement is compatible with my gateway... I like that too. Reasonable cost as well.
C**S
Perfect.
I took the output signal to a 120vac comtactor to shut off my clothes washer due ti discharge sink over filling. Sometimes my drain is slow. This works well. No complaints.
J**H
Water cooler shut off.
We bought this because we have a water cooler that occasionally leaks if the pump gets stuck on. The water cooler sits on a mat in the barn and we have the sensor sitting down on the mat. If the pump stays on and leaks, the sensor reads it and the relay kicks on and turns off the system. I have a 12 volt power supply separate from the cooler to power this up. Pretty slick switch for $20.
J**E
Preventing water damage
Pump house
B**B
Manufacture did not solder one of the relay pins
THe NC contact of the output relay was not connecting with the COM of the relay. I removced the circuit board from the enclosure and found the NC pin void of any solder. Also the specfications state 10uA of standby current. This si compleatly wrong. There is a green power indicator that is allways lit and consumes 10mA alone. I had to remove the LED current limiting resistor for my low power application. Standby current is now abount 1.2mA.
S**A
works better than expected
I pre wired home for 7 sensors but my alarm panel couldn't handle that many in parallel. When I found this device I though is may have some issues but I was surprised how easy it installed and worked first timeI wish is came with it own power supply but I happen to have an old 12v one lying around
F**B
Work as I expected
I used this unit as a emergency shutdown the machine if some leak in our pump unit
Trustpilot
5 days ago
2 months ago
