Compatible with CRF 250L CRF250L 2013-2021 LED Brake Tail Light Turn Signal Blinker License Plate Holder Rear Tail Tidy Fender Eliminator Kit

I wanted to replace all of the facotry lights to LED, so I installed front blinkers (Acelane Motorcycle Led Turn... https://www.amazon.com/dp/B08P1WSTJ6?ref=ppx_pop_mob_ap_share)a fender eliminating tail light kit (Compatible with CRF 250L CRF250L... https://www.amazon.com/dp/B08TCBWFJ9?ref=ppx_pop_mob_ap_share)and flasher relay (2-Pin Electronic LED Flasher... https://www.amazon.com/dp/B073J82PNF?ref=ppx_pop_mob_ap_share).The flasher relay was a plug and play harness and I was able to use the rubber mounting bracket for it too.I attached pictures of the wire colors to match with the stock connections. Hopefully you can zoom in to the different angled pictures to see where each color goes. I think they could have done a better job providing this information, but a little time with alligator clips and trial and error led me to the solution. I chose to cut the harness off the stock lights to simplify the splicing. I soldered them together and used heat shrink tubing to protect the connections.I really like the cleaned up look with this kit and the price is what I was willing to spend.

It works very well but I wish it came with a wiring diagram. I waited a few months to see if it would stand up to abuse. It does but I wish it was built better and brighter. I'm giving it 4 stars because it was cheap, does the job, looks way better. But there's room for improvement for sure.

Definitely a cheaper tail tidy and not auper bright. We'll see how long it lasts but for the price it's a good value.

Not an easy install. After looking in the comments section I found someone who posted pictures of the wiring. I got it all hooked up correctly and tried it out and the left signal doesn't work at all. And neither does the brake light. Sent a message to the company, got no response. Don't waste your time.Edit* seller responded to my email saying they would ship a new one but no response after giving my address. I will edit further if/when new one arrives

It’s not plug and play, and the light feels really cheap, it’s a good replacement on my 2019 Crf250L. I had to use the pic of the wires on here. It does it’s job just wish it was a little more sturdy.

Cleaned up the tail of the bike great. Fit perfect and looks way better than the bulky stock setup.

NO INSTRUCTIONS, I had to use the photo off the Amazon listing to know what wires did what. This is how I connected my wires and everything worked perfect, just cut the wiring harness off old tail light assembly and connect to wires on the new light. I used a wiring diagram for the 250l I found online....or you can just use my photo. Looks great and eliminated a lot of junk on the tail.