Baby Proofing Edge & Corner Guards | Safe Edge & Corner Cushion | Child Safety Furniture Bumper | Table Protectors | Pre-Taped Corners | 20.4 ft [18 ft Edge + 8 Corners] | Onyx Black

Good quality

The glue is super weak. It doesnt work at all.

Muy mal producto no nos gustó nada está demasiado grueso se despegó al dia siguiente huele muy feo yo creo que hasta toxico es y muy flamable no se puede ni lavar con jabon tardó demasiado en llegar

Great product, just like the image and very easy to use. The double sided tape for the corner pieces has an easy to peel edge, which we really appreciated. Looks good on our glass coffee table

We had some issues with some previous baby proofing systems... my kid has a scar on his head because of the other guys... this system is rugged and the glue holds and has saved us from a few emergency room visits. Great value for money

The foam does not stay in place due to poor quality adhesive

I bought this because I have a brick-mantle fireplace in my living room and two active toddlers who don't quite grasp the meaning of 'pointy'. To start, the preparation was a lot of work. For an approximately eight-foot run of brick, I spent about two hours getting everything installed. However, a lot of that was me cleaning the brick in the hope that I would get good adhesion from the included tape. This was vital. Most of the rest came from checking and re-checking measurements. I found that it is better to leave it a little long and trim the end than to risk having it short; note that this material will stretch if you pull on it, so getting correct measurements can be tricky. The instructions say to stretch out the roll for several hours before use, and that is also vital. You may want to stretch the tightly-coiled end for longer than that to get it to relax. The material cuts easily with a utility knife, though cutting it straight tended to be more based in luck than skill. Use a new blade. Heavy-duty scissors might work, but I didn't try it. The included pre-assembled corners were very nice and took out a lot of the guesswork, but they introduced different guesswork and complicate my measurements a bit. I probably would have had an easier time had I simply run the roll to the edge, cut it on an angle, and made my own corners, but on the balance, I'm glad that I used the pre-assembled ones. Once stuck on, you won't have the opportunity to adjust. Be careful. If your small child (or large child, pet, spouse) rips it up, it will stick back on without too much hassle, but there is a definite limit to the number of times that the adhesive will tolerate this. Be prepared to use your Stern Parent Voice. I got it to last about five months with two three-year-olds, and then I had plenty of adhesive left over to reattach the edge. It has saved skulls a few times now, but I will caution that this is not a complete safety barrier. Hitting the head on this edge still *hurts*, and the flat surface remains unprotected. However, it has prevented a few cuts, concussions, and general scarring and blood loss, and I figure that when it detaches the second time, my children will either be old enough not to need it, or wary enough to avoid the mantle.