Loctite Epoxy Instant Mix 5 Minutes, 0.47 fl oz, Instant Mix Syringe (Pack of 6)

Its not that strong glue what i expect to be , but is doing the job.

The Sharpie pens received worked nothing like the epoxy resin I ordered

This adhesive—or epoxy—is so efficient, and so well-suited for application using the syringe method, that you avoid any waste or errors. I highly recommend it for the specific purpose I use it for: repairing speakers or re-coning speaker drivers.

Quickness of sealingUsed to attach metal lamp to cement base.

Sehr zu empfehlen. Gut für unterwegs.

I can't speak to other applications but this was exactly what I was looking for. I needed a strong epoxy which would flow well into crevices but was thick enough not to run all over, this is about the consistency of cold maple syrup upon dispensing but hardens within a few minutes to tacky and then starts to solidify. I had a barrel shaped wiring harness with a number of wires close together, which would move and touch each other at extremes. I applied the epoxy to the wire ends, which were soldered in place, and then wrapped tape around the area to make a tube and then filled the area to make a solid epoxy plug. I did it once and let dry for a few hours and then did the process again. The result was exactly as desired, all the wires are encased in epoxy and the strain relief slides over the epoxy plug. The epoxy resin cures up very hard in 24 hours but it does not seem to be brittle. It fills gaps well and is not difficult to work with. If I was using this for any other application, I would ensure the work I wanted to connect was sanded and de-greased, to provide the epoxy something to grip onto. Perhaps this is the problem some folks are having who have rated this product low. I found it perfect for my needs.

Used it for the first time so i has some trouble initially. But glue is strong and i have no complaints. The instructions say point up to let bubbles rise but the opaque label sticker on it blocks entire contents of tube from view. You can rip it out and then follow the instructions. I also messed up while doing the "pull plunger back a little" part and ended up popping it out and getting glue on my hands and hurried to get it back in. Worked well for the first application. I set aside the glue tube for 2 minutes and tried to continue with application and the glue at the nozzle had already dried. tried a few things but couldnt get glue to flow. Luckily they gave a second nozzle. Switched to it and applied all the glue in one go this time.