HobbyPark Aluminum Caster Blocks C-Hubs & Steering Blocks Knuckles for Traxxas 1/10 2WD Slash, Rustler, Stampede, Nitro Slash, Replace 3632 3736 (Navy Blue)

Product seems to be well made.

My 2WD Stampede must be 14 years old, and these parts fit perfectly. The included hardware won't be everything you need, you'll have to reuse some of the original screws and bolts. Also, make sure you use Loctite blue or the included hardware may back out over time. I'm very happy with how easy the install was.

These work great if you wanna put hex tires on the front of your Traxxas Jato 3.3. All you have to do is drill out the bottom pin to accommadate for the bigger pin that slides through the A arm. Also added a shim to remove any extra play. Would buy again!

the rod that connects the castor block to the steering knuckle is arguably the most important piece of hardware, along with the tiny e-clips that secure it in place. this set is very nice, and theres a couple extra pieces here and there, mainly the small nuts and washers, but nowhere in this set is the connecting rod, or at the very least a couple e-clips to replace the ones that were lost in the crash that broke my cheap stock castor block and bent the connecting rod. i can straighten steel, i cannot materialize it.*Update: 10 minutes later i've decided to just put the car back together as best i can until i get some hardware, until i noticed something that just ruined the value of this set entirely. if you want this set as a replacement, you will need connecting rods for the castor block and steering knuckle, and you will also need allen bits or allen keys that are very small, and very specific. now i not only need to get some e-clips, i need to get *another* tool kit just for my castor blocks. i tried using the stock hardware but the threads dont fit. i'll know better next time to just find a complete set that's either using phillips or torx.

Easy to install fit was great! Works flawlessly on my 1/10 scale traxxas slash 2wd.

The media could not be loaded.  Look great and would be awesome if it wasn't so much slop. Car doesn't go straight and looks like I have 7° of camber. For $11 I'll try to shim it or just use the c blocks

Very good upgrade for the nitro slash. Nice fit and not too much wiggle. Very nicely made!

I’m not an RC car guru, so take this with a grain of salt. I’m not impressed with these components. The supplied washers do not properly shim the axle. One washer is not enough, two is to much. I used two 5x8x0.5mm PTFE coated washers (not included) and they worked out well. But the thing I can’t fix is the slop in the pivot pin between the caster block and the steering block. The bore in the steering block is way to big, and the lugs are too far apart on the caster block. I tried to find something to shim the lugs, but I can’t find anything on hand. So now I’m got tons of slop in my front suspension. Would it have cost any more money to manufacture these with the correct bore diameter? Lesson: If you can’t afford the quality upgrades, stay with stock, as its far better.