Sovol Creality Capricorn Bowden PTFE Tubing 1M XS Series 1.75MM Filament with 2X PC4-M6 & 2X PC4-M10 Pneumatic Fittings & Tube Cutter for Ender 3/3 Pro/5/CR-10/10S 3D Printer

Excellent piece of essential equipment for a 3d printer. Easy to replace existing tube and works perfectly.

This tubing allows the filament to run better and last longer in hot ends that have the tube run through them. I have used on both an Ender 6 and Ender 3. On the Ender 6 the Bowden tube run is so much longer and was prone to have retraction and flow problems when the tube was slightly worn as the filament would drag a bit inside it. Using this tube reduced the friction and made flow and retraction more consistent. It's also a lot better when run inside the hot end. It does not degrade so quickly so printing stayed better much longer when running higher temp filaments like petg. It's obviously not as good as having an all metal hot end or direct drive but it helps (I also recommend using this between direct drives and all metal hot ends as well as I think it has made a minor difference).

Good quality items at a good price. Very easy to use fit well. Improves print quality.

Good for a replacement fits well and only time will tell

When one of my couplers gave up (would no longer grip the tube) and the ends of the originally stock tube were wearing out I bought this little kit as a replacement/upgrade to get me back up and running. All works well, although I am a little disappointed that they didn't include any of the little blue clips that are so easy to lose.

Easy fit and tighter tolerance than a standard ptfe tube, this one came with a cutter to ensure a nice square end. Just be sure to measure your requirements for length, not so long its flapping all over but not so short it's being pulled or kinked when your hotend is at the limits. Works well and keeps that filament flowing smoothly. There may be other options but this works well for me, just be careful not to run it at very high temperature or it will off gas. All ptfe does it so its not a fault of the product, just do your research before buying to ensure its right for your purpose.

Are you getting issues with your prints, clogs or filament flow. You might want to check your Boden tube. If it's bad replace it with this. Simple to install. Remove the old one, measure, cut it FLUSH (to avoid problems) and install. Done. Expert tip - When removing to old tube remove the nozzle and pull it through the nozzle end, it will grab any filament left inside and make sure the heat the hot end when doing thing and repeat the pull multiple times. It's a brilliant upgrade and improves performance on your printer for cheap

I upgraded the Bowden tube on my ender 3 neo. Best thing I did with this. Way better build quality than the one that came with the printer. Not getting any heat deformation from the hot end. Got a very clean cut with the cutter provided too.

Very nice

Per Chiunque abbia una stampante Bowden questo è un acquisto obbligato. So che alcuni arrivano col foro decentrato, controllateli prima di montarli, eventualmente ve lo fate cambiare. Il mio comunque era oerfetto

i have bought capricorn before, and the one i bought before looks exactly like the picture, however the one i recieved now was not, lower quality and just doen't feel right

Great product works well, feels high-quality, and is totally worth it. Would buy again!

Got this one because I needed a new tube and a cutter and it was all worth it, perfect upgrade for my kobra 2 extrusion tube