remote switch 110V 9400FT

What a great tool. We use it to control a fountain in our lake. It's advertised to work 1500 meters away from the remote control. That's 4921 Feet away ! One can hardly even see that far. We are only 500' away from the unit and it works great, and actually almost instantly. It also comes with two remote controls. Be prepared to know how to hardwire some basic electric items though. I cut an extension cord in 1/2 and wired it in and out of the unit. Get one !

Works properly 500 feet away through a metal building even without the antenna extended.

Very easy installation , I am using it to run 13 Anp. 2 HP central Vacuum motor It functions throughout the whole house . Using one remote upstairs and one downstairs .It paired right up all by itself. The only issue is the on off Battery is not clearly marked, for some reason it is designated. F or N not sure why .

So far so good. I have purchased a bunch of other other ones that claim they work up to 200 feet or so I'm not lucky if they work at 50 feet. But these here are working well over that I wish the remotes were a little smaller but I can't complain too much cause they are doing exactly what they said they would. For the price point definitely worth it. Don't waste your time on the smaller remote ones cause they do not work. I have purchased most of them.

Edit: it was a user error. It now works well for over a year. We use it to trigger Lights at far location on our property. However the unit stops responding to the remote control after couple of days of non-use. You have to reboot it by turning power off for a couple of minutes and turn it back on for it to start responding to the remote control again.

This set up is exactly what I've been looking for. Very easy to install. I have this to control my flood lights in a garage that's 150' behind my house remotely. So powerful, I don't even have to raise the antennas on each remote. Who knows how far away they would work? Fantastic....very happy and highly recommended.

I installed the remote inside a metal box, used it to energize a 240vac 40-amp magnetic for a 5 HP motor on a pressure washer. I fed the antenna out thru a plastic plug and mounted it on top of the box. I followed the setup instruction and the magnetic snapped it on the first push of the on button. I recommend this RC to anyone wanting a workable product.

1. The instructions omitted the need to place the remote’s side button in the “N” (ON) position during programming; both remotes came from the factory in the “F” (OFF) position. 2. Once programmed, the unit functions as a latching relay; that is, once turned on, the load (the device supplied by the relay’s output; a light, in my case) STAYS ON even if the remote’s OFF button is pressed. With this first remote (see below for the other problems with the other remote), the only way to turn the load off is to manually unplug the power supplying the relay. 3. To clear the memory, the instructions say “wring and Turn on the power.” Wring? Turn on what power? Supply power to the relay? Press the remote’s ON button? It then says “push this button 8 times.” What button? It doesn’t specify the button, nor is there an associated diagram illustrating it. Clear as mud! 4. After programming the other remote, it will turn the load off if I press the ON button twice. Strangely, the OFF button does nothing. Because the remotes include ON and OFF buttons, the load should remain on after the ON button is pressed until the OFF button is pressed. Unless the seller wants more unhappy customers, they should immediately revise their instructions and clarify the solutions to the problems noted above.