fischer Frame Fixing Sxr 10 X 100 T, Pack of 50, 46264

prodotto ottimo

Ich habe damit UD-Profil an einer uralten weichen Wand befestigt.

I would describe myself as an enthusiastic DIY-er. These are maybe the best fixings I have used for attaching treated 2x4 lumber (e.g. the bottom plate of framing) to concrete floors, like when finishing a basement. I did this a few years ago with Tapcon screws and found them much more difficult and less forgiving than these. Several Tapcons sheared under the force required to drive them home. I have used wedge and sleeve anchors and found them both pretty easy, but I don't really like the amount of thread and the nut on top of the rail because I like to add a row of noggins on top of the bottom plate to make it easier to secure the baseboards. I have also used hammer-sets, which are maybe slightly easier to use than these fischer fixings, and were probably my favorite until I tried these. For these, drill 110mm deep 10mm hole through the base plate and into the concrete, ideally with an SDS plus drill and bit. I tend to carefully hammer the plug down without the screw in it because sometimes I have driven the screw into the plug too early making it difficult to fully drive the plug home. The screw has a torx T-40 head, and I use a battery drill/screwdriver to drive the screw home. easy and very secure. Removal: Sometimes the frame ends up in the wrong place, and needs to be moved. Ideally this doesn't ever happen, and I'm a bit more careful these days, but mistakes do happen. My laziness wants to find the easiest way possible to fix the mistake. If one of these fixings needs to be removed, it is usually possible to unscrew the head partway and use a block and crowbar to pull the screw straight out - and most of time both screw and plug come out. If the screw slips out, it can be screwed back in a little further for another attempt. If I can't get a plug out I use an oscillating tool to slice through it under the base plate. Tapcons are usually easier to remove, (but if they sheared off then removal is a nightmare) and sleeve and wedge anchors seem impossible to remove without drilling more holes around them - though there could be a trick I'm not aware of. I have never tried to remove a hammer-set, and they don't look particularly easy to remove.

Fisher un nome una garanzia tutto perfetto

Avevo molti dubbi per questi fisher ma mi sono trovato molto bene .sicuramente li comprerò di nuovo