Minwax308240000 Wood Finishing Cloths, Dark Mahogany, 8 Piece

Easy to use and apply to bare wood.

My house is 17 years old. My kitchen cabinets still look great, but the lower doors under the sink had several small nicks where the finish wore off. I ordered these wipes and can’t say enough good things. My lower doors look just as new as the upper cabinets. Very easy to use and hardly any odor.

Bought these to refinish a similar-colored older but not fancy sofa-side table. Very easy to use right out of the package but quite messy.They come with gloves (a single one? a pair? I didn't unwrap them) but I used thicker disposable gloves we already had, one on each hand (and a new set for each layer of stain). You'll want the gloves. The stain starts getting on stuff (like the outside of the package) as you open the package. After the first swiping round, I kept a sandwich baggie handy so when I pulled one out to touch up small sections I could wrap that cloth back up for additional use later.The stain itself? Easy to wipe on. Seems to cover well - possibly too well (this may be the "too thick" comments others made). There seems to be plenty on the cloth at first but it transfers quickly. I found that folding the cloth back and forth got more even results. Dries very quickly, at least on the outside, so if you're going to go back and even it out don't wait more than a minute or two.Suggestions for improvements to the product and its packaging:Make it a little easier to open the package one-handed. Make it easier to grab the edge of each cloth without needing to stick your fingers all the way in. Have the opening closer to the top or bottom or an edge so it's easier to just pull a corner out for small touch-ups.

I used these wipes to stain and finish my mobile pieces. The ship's wheel piece is the main part thay was stained, but all pieces were stained in order to make the gold paints over the portholes pop more.I really liked this product and was very confused to read the negative reviews. Here's a few clarifying points:•When reviewers say "good for small projects," that's rather subjective. It would have been very silly for me to buy a whole can of stain for an 11" x 14" mobile, but these wipes worked great. Would I use these to finish an end table like the lady in the video did? No, just get a sample can of stain and call it a day.•Your first pass with the wipe does go on rather thick. The way I found that worked best was to thoroughly wipe down one side of my project, flip it to wipe down the other (non-visible in the finished product) side, and then go back over the front with the stain wipe to smooth out any drips/concentrated areas. 1 minute or so later, wipe off the excess with a towel. Worked great.•Not sure who I need to say this for, but you still need to sand after you stain. I also finished my pieces with clear acrylic paint and then sanded that, and the end result was nice and smooth - almost soft.Definitely use this for small or flat projects. If your finished piece is bigger than a microwave, just get the can of stain and a brush.

I am a professional refinisher for 30 years. I bought this to do a wood top I made and just needed a one time use, not a can to sit around and go bad not using what's left.That said, this product is too thick, and dries too fast. After you apply it, you have to wipe off excess. The top is only 16 inch by 28 inch. I did half at a time. It only takes seconds to wipe it on the half, but by the time I go to wipe off excess, it's already dry. Covering up the wood grain. I had to use a rag soaked in alcohol to wipe off excess and expose the grain. Regulat alcohol will work, denatured alcohol is better. Acetone will also work. A regular person won't know how to compensate for the extra thick, super fast drying problem like I do.I suggest doing a 6x6 inch spot at a time, and quickly wipe away excess. When you've done the whole thing, go back with rag soaked in alcohol and wipe the whole thing again, blending in the area's of overlap.It can come out a little blotchy even with these steps. Use sanding sealer prior to stain to get more even absorption.Stain should be very runny like water. This is too thick. Maybe past it's shelf life.

This are GREAT! I didn’t need to sand , I recommend letting it dry in between coats. You don’t want to go over any wet stain because it will peel. They also do sell a sealer if you want to be safe. But this works so well and the finish is beautiful

This is one of the worst products I have ever used!! The video about it showed some woman using it to stain a peice of furniture. She took the wipe and rubbed it across the wood, and it just glided on so smoothly, almost effortlessly.I thought it would be just that easy. WRONG!!! When I opened the package( that was completely sealed). I made the mistake of not testing it first on some wood scrap. And when I began to apply it, it was a half dry, sticky mess. I had to use a lot of pressure to cover it, and the cloth kept stopping and dragging on the wood. There were bare spots, and when I tried to go back and cover them, the cloth would stick and the stain sometimes balled up. And every where I held it while staining it. There are dark blotches where my fingers were. And I even used brand new powder free latex gloves to keep it clean and keep the stain off of my hands. The stain went on very uneven, and it is supposed to be Maple. Which is supposed to be a Yellowish golden brown color, and this turned out looking Orange. It doesn’t look at all natural. Like any, really good wood stain would. I have used stain numerous times before and always had good results. The thing that made so angry, is that this is a Minwax product. And I have always had positive experiences with this brand. I trusted again. And this time It ruined my project. I had both time and money in this project. And now it looks like crap. I won’t ever buy this product again. And J might not use Minwax products again either.