10pcs Magnetic Nut Driver Set, 1/4" Quick-Change

The drill driver itself is as good as others I have purchased; however, the magnet is so far inside of the bit that it doesn’t not hold onto screws. Basically, if you’re looking for a non-magnetic driver go for it. Otherwise buy a different bit.

So far so good I’ll have to try it out to give a comment

Needed some hex head bits, and wanted to try out a non-name brand. So far they have lasted as long as the name brand ones do, at a fraction of the cost, I will be buying more when these are done. I haven't had any issues with the magnets falling out yet.

So, sure .. these aren't as good as some of the tools I've filled my box with but .. they're good enough. Every once in a while, one will just give up the ghost and the side will blow out. No sweat, grab another and get right back on it. if you're more concerned about getting the job done than you are about what your "work buddies" think .. these are right for you.

The magnets on these are not nearly as strong as the name brand ones. I'd say, " good for short screws." Ive gone back to the name brand ones to keep from dropping screws

Not good I ordered two packages and today i used two of them and the little round magnet is coming out I will not order any more again

I use these bits to remove sheet steel roofing. The bits st and up to this brutal salvage chore. Very good buy

Excellent quality, great value, rapid shipping

Doing a big Tapcon job and knew I would go through a few of these. (800 tapcons) I have stripped out 3 so far, and done maybe 500 tapcons at this point. I am very impressed. As you know we never are square on a head, but these guys just kept driving those bolts.

Work well and good selection of sizes

Fast shipping works as they should

Fits and works however the magnets come out of the product very quickly and then it doesn’t hold screws well at all.

These were junk. Strip super easy, super soft metal. Good for 10 screws max.