Instant Smile Comfort Fit Flex Upper Teeth Veneer Natural Shade

Not very good , if they had held in place where they nearly stuck to my teeth during moulding they would have been great. Wouldnt stay in mouth afterwards, would never be able to wear out , waste of money for me

I'm currently waiting for dental treatment after a 9 year wait for an NHS dentist. I have missing front teeth and will need top dentures but this is a long process (had a consultation and xrays and now awaiting the next appointment in a few months). I've been using these insta smile veneers for the last year or so with great results. I had previously tried cheaper versions but the teeth on them looked super fake and looked like a set of Billy Bob teeth. Due to the amount of gaps/missing teeth/partial teeth, I use the insta smile along with some white thermal plastic beads to create a full top denture over my existing "remaining bits". I put the original kit in a mug of boiling water. I add a little red food colouring paste to the white thermal beads to match the original pink plastic that comes on the veneers. then put additional thermal beads and food colouring into another mug of boiling water and leave them to melt for a minute or two. Once I've moulded the original kit to my mouth, I then add the additional thermal beads around the inside area to create a full top denture set. You need to remove them quickly during the fitting process whilst the plastic is still warm. If using to cover remaining teeth, my tip would be to wiggle backwards and forwards a little bit as you remove the kit to make the "tooth holes" big enough as the plastic seems to set slighly tighter than when it is when still flexible meaning you could have issues removing them (yes, it's happened to me when creating a new set). I find chipped enamel causes a lip on which the veneers can get stuck when trying to remove them. If you do get them stuck, get some water (as hot as you can handle in your mouth) and hold that water in your mouth to melt the plastic enough to remove. If this fails due to not being able to have the water hot enough, I found sticking a flannel/cloth in boiling water and holding/biting it in the stuck area will help melt it enough to remove. I can eat with them in and smile without covering my mouth once moulded correctly. I find in order to be able to eat with them in and not have the teeth falling off the moulded plastic/getting chipped or damaged etc, I need to mould the kit so that the pink strip tapers and meets the inside lower edge of the veneers teeth and if possible, around the top and side edges of the veneers. Whilst they're never going to look like "perfect" teeth, they're totally passable and other people don't realise they're not my teeth (including my partner of a 8m, were both going through dental treatment for dentures but he's never seen my actual teeth). These veneers look a darn sight better than the stumpy damaged mess that remains in my mouth. It affected my mental health and self confidence massively walking around with missing teeth. I felt so terrible as a middle aged woman walking around with the messy mouth is. These top veneers have saved my sanity. I've been wearing them for so long. Each set last me a few months before I meed to replace due to discolouration from smoking/spicy and coloured sauces etc. In all the 9 sets I've previously had, only one set has ever become damaged and a tooth split off the original plastic they're fitted to and that was caused by pressure on the "tooth" whilst eating, leaving just the pink plastic behind it and the rest of the veneer in place. This is what then made me taper the thermal plastic to the edge of the teeth and around the back edge side of the veneer kit. Since then I've never had issues with the teeth coming off. As my teeth are already set for removal and awaiting treatment etc, its just going to be a long wait and process to get denture sorted. In the meantime I do wear the veneers 24/7 but remove and brush both my teeth and the veneers several times a day to minimise damage/staining/stuck residual food after eating and more if I'm smoking more than usual etc. I then soak the veneers in steradent tablets to deep clean them while I shower and then pop them back in. These will cause damage to existing teeth due to holding whatever you've eaten/drunk around your current teeth so if you're planning on saving teeth rather than removal, do make sure you remove the veneers and only wear them when necessary to minimise risks to your current teeth. If like me, you're set to have them removed, what difference will it really make as they're already beyond saving! These can be such a great product, just take your time with the application process and get the veneers up to the correct position so they look as natural as possible. You can remould them by popping into hot water again as many times as needed to get them fitted just right. I found if one side feels perfect and the other a little tight, I've held the side that needs tweaking back in the water whilst keeping the correctly moulded side out of the water helps to get the fitting just right. I'm looking forward to the day I get my permanent dentist provided set of dentures as I know they'll be better in terms of both looks and functionality but until that happens I'll be using these veneers and am able to eat unlike without them where I struggle to chew etc. I'll try to add some pics/videos of the process the next time I mould a new set in case it helps anyone else in my position to be able to get these to work for them. Give them a try, they could just change your life and give back some probably much needed confidence. We all know how people missing teeth etc are viewed by others, so it's great not to have that instant judgement from other people.

There are times when you say to yourself, "i will ignore the reviews on this one this time, because, you never know" Big mistake, they are the biggest waste of money i have every come across! Not only do they not fit properly not matter how many times i tried to fit them and it tried following the instructions to a T, they look hideous!! So take my advice and don't bother, or just throw your tenner in to the nearest river!! its the same thing!

A front tooth crown fell out just in time to have some important event photos taken in a few days. The dentist couldn’t repair it, so I need a denture which won’t be made in time. After trawling Amazon to look for this ‘kind’ of product which seemed to be all abysmal or fake reviews from poorly translated Chinese. A very kind lady has written an extensive review on fitting these which I followed carefully, and after a few Bugs Bunny moments got them to where I wanted them. I was amazed, initially they looked like joke teeth from a Christmas cracker, and very rigid, but once you soak them in near boiling water for a couple of minutes the mouldable fixing on the back goes very soft, and the teeth become very pliable. I’m very pleasantly surprised, and definitely think following the instructions to the letter and perseverance - in front of a mirror is key. Once you are nearly there reheat them for less time and tweak where you want them to sit. Definitely give them a little wiggle and remove them before they fully set otherwise you may have a problem getting them out. Once they’ve set hard again you can pop them in and out easily. Give them a go, and persevere. Having said all the above, I’m not sure if they worked so well because my ‘gap’ provided an anchor point, but they fit my other teeth well too, so who knows. For me, they are worth every penny. I’ve attached my before and after pic to the review so you can see how good theu are.

Inferior product not strong quality

Right, like others have said, these can be fiddly as hell to get right. I did have to do some sanding off of the pink adhesive ( clear would be so much better ) also the front four teeth are slightly short ! Some people said you get a lisp with them but that’s only if the adhesive goes beyond just covering the back of your teeth. I would advise to take away some of the adhesive ( once it’s soft remove some but keep it in case be ) before fitting and making the mould. You can obviously feel them in your mouth but that’s a given with any denture. I also used a little fixodent but it’s not necessarily needed. Overall I’m pleased with the product and result, even though had to do a little tinkering. It won’t make your lip stick out if you don’t use all the adhesive and if you press them firmly against the gum when you take the mould. Put it this way, it’s a lot cheaper than buying dentures through a dentist etc, so faffing about is worth it, we’ll it was for me, just need to get the bottom set now to balance the colour out….…. But definitely need those middle four to be ever so slightly longer and then I’d have given a full 5 ⭐️ when I first wrote this I was struggling to get full comfort. Now I’ve tried moulding them without the adhesive, and I stick them onto my own teeth with fixodent and you wouldn’t know you’re wearing them 😊

Whilst paying £22 for this product and receiving what I can only describe as "Joke Shop material" It's nothing like the advert described and poor quality,How these companies get away with selling these inadequate products.All I can say is Stay away and save your money.There instructions are useless and the dentures are nothing like on the advert.Great packaging though to make the product look far more superior than it actually is.

They are not as they seem you actually need teeth as they clip on to your own not worth the money as this is not made clear

Dinero tirado, no es la arcada superior completa, el sistema de pegado y fijación es muy malo y la talla no da para una boca de adulto. Un desastre

terrible dont waste your money

Très content 🤩🤩🤩🤩🤩

E' arrivato fallato.

You get what you pay for, and even when you go to the dentist, everything’s custom fit to your mouth. So these took some customization to work, I had to sand down the gum line, with my dremel. I also purchased additional wax balls on Amazon, because what they provide in the set it’s more like a starter kit. Not sure how long it’s supposed to last, but I like having backup molds, and I eat with mine in, so I’ll have to changeout my wax more often than someone who takes them out. I guess that’ll depend on your situation, my teeth underneath are doing all the work, so I’m able to getaway with it. I can repeat the entire process for replacing the wax in about 5 minutes, getting the veneers to look good, I’ve only had to mess with the first time, now I just mess with the wax. So if it takes you a little time at first, don’t get discouraged, once you get the veneers to your liking, u finished the hard part, the wax you can heat up over and over again to get it to your liking Make sure to put the veneers in the hot water when you first get them, so you can mold them over the shape of your teeth. Like I said, I only had to do that once, and haven’t done it since. This products for someone looking for a cheap alternative, to buy more time for dental work, or a quick fix for self confidence. Like a messed up tooth, self conscious about a gap, or even if it’s the color and you want something brighter white. I’m sure others do the same, but I always was very careful about the way I spoke to ppl because of two of my upper teeth that I damaged in an accident. Prior to these whenever I was talking to someone I didn’t know especially, I was constantly making sure my lips didn’t expose my upper teeth. Smiling, forget about it, a smirk was the most you’d get out of me. Since I purchased these veneers, I can’t believe how much of my time I wasted worrying about my smile. SMH, I wish I knew about these sooner. If you end up getting them, invest a little time on social media, watching ppl’s reviews. That’s how I figured out what worked for me. They helped me make these veneers look natural instead of a mouthguard. I don’t work for them, or get annything in return for this. I’m just happy for the first Xmas in three years, my teeth will be the last thing on my mind. I went ahead and purchased a backup set, that way if anything ever happens I have a backup already made and ready to go. Not sure how I can help anyone anymore, but if I think of anything I’ll update my review? Wish you the best, and fingers crossed you get the same relief, don’t forget these aren’t dentures, and you aren’t going to get a perfect fit, you need to do that, but with a little time it’s possible.