A-Premium HVAC Heater Blower Motor Assembly Compatible with Hyundai & Kia Vehicles - for Accent, Genesis, Tucson 2010-2021, Veloster, Borrego, Rio 2006-2011, Rio5, Sportage 2011-2022 - Replaces PM9359

This was a perfect fit for the 2013 Hyundai Accent. Three screws and one wire harness to unplug makes this an easy repair that takes about 15 minutes. Highly recommend this blower over the more expensive ones at the nearby auto parts store. Saw other reviews that described the fan as noisy, but this one was as quiet as OEM. Highly recommended.

The whine isn't terrible and can be pretty easily tuned out with music playing in the vehicle. I did figure out the whine is in the same key as Seven Nation Army, so there's that, lol. It was relatively easy to install, and it works great.

This feels and looks like a quality product with good construction and does fit inside, BUT the cable from the 2016 genesis coupe for the motor isnt long enough to connect because of the offset cable insert.

Perfectly made, installation was super easy.Super quiet while in use.would buyfrom this vendor again and again.

The wiring plug location does not allow the blower to be installed without adding screw holes to the car or modifying the wiring harness. It's a friend's car so i dont want to do any sketchy repairs. The motor gets 2 stars as it otherwise works and could be made to fit with a 3-inch wire extension adapter.

Easy install due to Hyundai engineering, but part us a perfect fit. I had to clean the weep hole out because of a whistle when it was in. Seriously just a small piece of plastic in the hole making the whistle noise. Small drill bit by hand while running, it blew right by. It's well worth the money

Fit great in a 2014 2.0 tuson... ghs or whatever, the cheapest one

I purchased this fan for a 2012 Kia Sportage. The fan shipped quickly, was well packaged and even included an extension for the wiring harness because the power and control wires are in different places depending if it’s a Hyundai or a Kia.The mounting holes are in exactly the right spot, and the fan fit perfectly. Removal of the old fan and install of the new was done in under 15 minutes.Unfortunately, there are two problems with the new fan, one hopefully temporary and one unfortunately permanent. The hopefully temporary one is that the fan gives the air a plastic-y, chemical odor. Hoping that fades after the fan has been installed a while.The permanent one is that this fan is much louder than the stock fan. The stock fan can’t really be heard over the noise of the air moving when it’s on high. This fan can. The best comparison I can make is it sounds like your a little down the call from someone using a hair dryer in a closed bathroom. You can easily hear the noise of the fan over the air, even on high.