BEAMNOVA 6mm 1/4 Inch Hole Punch Die for Hand Press Grommet Tool Kit

These punch guys are extremely well made and should last a very long time. I strongly recommend them and I strongly recommend the seller.

I needed to punch a lot of holes for some bracelets and didn't want to do all the pounding with a regular hole punch. I tried this because I could use it with my KAM press at a much lower price. It worked great on the glitter canvas I used for the bracelets. as you can see in the pictures clean holes and continued to cut through all the 117 pieces that each had 2 holes - that's 234 holes nicely punched. I am so very pleased with this.

It works great. The only downside is that it makes a hole bigger than the grommets I would like to use.

Purchased to work with QWORK Unit. I was wrong, it was upside down and would not fit. I was confused as the proper size hole end was supposed to be 1/4 inch. However when put in the correct way the hole was 1/16 inch or even less in diameter. I drilled a 1/4 inch hole but the device was to low and my upper component would not reach long enough to punch all the way through a soft cardboard about two mm thick! I will buy a washer to bring it up in height (about 3/4 inch id) and try it. It's confusing buying a new device, when they send the wrong part !

I bought 2 of these dies for my green machine The smaller 6mm punch works on a single sheet of material if I put some lightweight card beneath but the 10mm one doesn't punch at all it is too large and the material just pushes into the hole without cutting wasted my money

Perfect fit for generic handled punch! Quality is good and tested on muslin fabric.

Not well machined. Functions but seems crude. It is much like the setters that go with the press.

This made all the difference in putting in grommets and having them turn out good every time. I am very pleased with my purchase.