Mopar 82215285AB Pickup Box Utility Rails Ram 1500 W/ 5.7 Foot Bed W/O RamBox

Very easy to install. Excellent fit and took less than 45 minutes from box to completion. The rails allow for quick attachment of rope or tie downs. Instructions were extremely easy to follow.

Exact fit. Easy to install. Had to get a rivet nut tool from O'Reillys auto. Cost was less than $10. Had to drill out the holes just a little due to my spray liner.

The box was only banded with tape at each end. The box was not in good shape with the middle open. When I opened it everything had shifted in the packaging, but it was all there. There were also footprints on the rails, not sure if these were used or not. I bought them as new. Some parts are scuffed due to bouncing against each other in the box but not worth sending back. Overall a very nice product. Just wish it was packaged better. The install was quick and easy. I would suggest purchasing a rivet nut installer to save time and effort.

Arrived with no damage. Very easy to install. I used a small round file to remove the excess spray in bed liner from the holes. You do not need a rivet gun. Just follow the directions. I had them installed in less than 30 minutes. I did tap the self rivets in with a hammer. If you don’t have a spray in bedliner, they will pop right in.

I took other reviewers advice and purchased a rivet tool. That tool is still in an unopened box and needs to be returned. The rails come with special anchors which fit in (in my case) pre-drilled holes in the bed. Due to my spray-in bed liner, I had to drill out the holes slightly. Even still it was a snug fit to get the anchors installed, and I used a hammer to tap them in. The anchors seat themselves by screwing in the bolts, which you do before installing the rail. I used an impact driver just to speed things up. Once seated, you remove the bolts and install the rail. It was super easy and no rivet tool was required. The rail was new and in perfect condition, unlike some of the other reviewers. Install took about 30 minutes, including the time to figure out the instructions which don't have any words. :)

Box was beat up. Look like these were used and not new and had missing and broken parts. But it did install easily when I got everything together.

What I like is that the kit has everything you need to install. What I disliked is the instructions are poorly written but reading outside reviews and blogs you can figure the install out. The rail is well made. I would recommend using a rivet tool. The hex shape nut will not sit well if you have the spray in bed liner. I was careful and used a Dremel tool to remove the bed liner spray from the holes without rounding the hole. However, when I went to torque down the nut based on the instructions the nut just spin. This is where rivet tool comes in and made the install very quick and easy. I found an inexpensive rivet tool on Amazon. All tolled the part and the tool was still cheaper than the dealership!

Sturdy solid and adjustable. Fits like a glove. It does block the bed light inside a bit. If you have a factory spray in liner the nuts can be a little hard to set. Also a rivet tool is a must or else the nuts will spin. Once set these rails go in perfectly.